Replacement medium-grit abrasive sleeve for a 2" long rubber sanding drum with a 1" diameter. Includes 3 per package.
With just one Diamond Wave Sharpener, you can now properly maintain the cutting edges on a wide range of curved cutting tools, such as in-cannel and out-cannel gouges, carving tools and wood turning tools. The uniquely designed Diamond Wave features a variable radius from 0.0625" to 1", accommodating all curved gouges, and it's the first diamond sharpener to combine convex and concave abrasive surfaces. It's easy to use - just slide the tool along the wave to match the radius, then sharpen with short back and forth strokes. Fine Grit: 600-mesh/25-micron. Made in USA.
Using CA glue to finish your pen turnings results in a lustrous, glossy polish,but it can also fuse your pen blank to the bushings. Not so with these non-stick polyethylene bushings in place, however. These bushings are made fromUHMW, the same super-slippery polymer used in our Plastic Jig Stock. They'repre-drilled for a standard mandrel, and have a 60° taper so they'll fit most anysize pen bushing. Just swap these for your metal bushings once the pen isturned, and apply your finish. 4-Pack.Technical Details:Non-Stick Pen Bushings are made of UHMW (Ultra-High Molecular Weight)polyethylene.Pre-drilled for a standard 7mm mandrel (e.g. 43537, sold separately).60° cone-shaped taper fits any size pen bushing.After shaping the pen blank, replace the metal bushings with non-stick plasticbushings and apply your CA finish.Self-lubricating UHMW has a low coefficient of friction, so it sheds glue easily.Very stable - 10x heavier than regular high-density polyethylene.High abrasion resistance and high impact strength even at low temperatures.Resistant to chemicals.
Norton Bluefire Rapid Cut chop saw wheels feature an upgraded abrasive blend of zirconia alumina and premium aluminum oxide, resulting in a wheel with two times the life and cut rate of standard aluminum oxide. The wheels are centrally reinforced and sandwiched by exposed rough sides for free-cutting, non-binding applications where minimal burr and burn are the key requirements. Use with a chop sawCentrally reinforcedType 01 wheel shape (flat)Ideal for mild carbon/high tensile steel, as well as cast iron, stainless steel and alloysZirconia alumina/aluminum oxide abrasive