Replacement medium-grit abrasive sleeves for 1-1/2" x 1-1/2" rubber sanding drums. Package of 3.
Whether you're cutting sandpaper to fit your palm sander, or just dividing the sheet into more manageable sizes for hand sanding, our Sandpaper Cutter will do the job quickly, cleanly and effortlessly. Just slide a standard 9'' x 11'' sheet of sandpaper into the slot, align it with the fence at the bottom and the appropriate reference line on the on-board scale, and tear it off. Sheets can be sub-divided as required to fit 1/4-, 1/3- and 1/2-sheet sanders. Built from sturdy 18 gauge galvanized steelSticker displays gauge lines for common sandpaper sizesMounting holes allow you to mount it to the wall or to your bench (mounting hardware not included)Can also easily be used free-handHang hole provided for easy storageMade in USA
Using CA glue to finish your pen turnings results in a lustrous, glossy polish,but it can also fuse your pen blank to the bushings. Not so with these non-stick polyethylene bushings in place, however. These bushings are made fromUHMW, the same super-slippery polymer used in our Plastic Jig Stock. They'repre-drilled for a standard mandrel, and have a 60° taper so they'll fit most anysize pen bushing. Just swap these for your metal bushings once the pen isturned, and apply your finish. 4-Pack.Technical Details:Non-Stick Pen Bushings are made of UHMW (Ultra-High Molecular Weight)polyethylene.Pre-drilled for a standard 7mm mandrel (e.g. 43537, sold separately).60° cone-shaped taper fits any size pen bushing.After shaping the pen blank, replace the metal bushings with non-stick plasticbushings and apply your CA finish.Self-lubricating UHMW has a low coefficient of friction, so it sheds glue easily.Very stable - 10x heavier than regular high-density polyethylene.High abrasion resistance and high impact strength even at low temperatures.Resistant to chemicals.