Whether you're cleaning up rough patches on a carving, ferreting out dried glue from a corner, or removing rust, paint or corrosion, Sandits make the perfect, low-cost tool for the job. Sandits Wedges are slightly thinner at the tip than the original Sandits, and slightly wider and flatter for better sanding of flat surfaces. They have 120 grit tips on one end, and 180 grit on the opposite end. Since the abrasive is embedded in marine-grade epoxy, Sandits are ideal for marine use or in wet applications. Use on wood, metal, plastics-any place where you need sanding, shaping, smoothing or polishing. 120-grit on one end; 180-grit on the opposite endTip is 5/16''W, with a thickness tapering from 3/16'' to 1/8'' at the tip (dimensions are approximate)5-13/16''L overallAluminum oxide abrasiveVersatile, portable, non-conductive and waterproofLow-cost; no need for a power outletGreat for cleaning electrical contacts
Check out our combination grit sharpening stones and keep your tools in peak condition! The 3-Piece Waterstone Set is a sure savings over buying the individual stones. The set includes one 800/4000 combination waterstone, one 6000 single grit waterstone and one Nagura stone.The 800/4000 combination waterstone is great for removing smaller nicks and for finish sharpening of woodworking chisels and other tools.The 6000-grit waterstone creates a polished edge.The Nagura Stone forms a paste on finer grit waterstones to speed and enhance polishing. Use with the 6000 grit stone.These stones can be reflattened after sharpening wears the surface by wet sanding the stone on a flat surface with silicone carbide wet-dry abrasive sheet.
Pack of six 6000-grit silicon carbide abrasive belts for the Work Sharp WSKTS Knife and Tool Sharpener (40323, sold separately). Intended for honing applications. Similar to honing with a leather strop. Highly conformable to hone gut hooks and serrated edges. Very cool cutting for the most delicate blades.
Coarse and Medium pads are excellent for stripping operations and paint removal. Fine and extra fine pads are great for knocking down raised grain before the first coat of finish, and for removing "nubbies" between coats. Because they're synthetic, they're perfect for water-based finishes where steel wool would cause rust problems. Non-woven technology means they won't shed abrasive crumbs onto the finish. Best of all, they're completely washable; just rinse them out under a tap to renew the abrasive qualities.