Secure your 2-1/2" hoses and fittings with these steel clamps. Use a flat-bladed screwdriver to tighten. Also available in package of 5 (sold separately).
By moving the primary handle to the rear of the tool, Triton's engineers have created a belt sander that can be turned upside down for use as a stationary sander. The included clamps slip into a pair of openings in the housing, firmly holding the sander to the bench. This is an ideal feature for sanding small or delicate parts. The front bail handle can also be pivoted out of the way for this purpose, or pivoted vertically so you can get the nose up close to a wall when sanding wood floors, for example. One side of the sander is also flush with the belt for the ability to sand directly up against a wall. The powerful 10A motor with variable speed control promises rapid stock removal and the ability to tailor the tool to your task. Small diameter front roller improves sanding in confined areas and detail work. Side dust port connects to included dust bag or vacuum system. Includes inversion clamps, dust bag and sanding belt.Features: Powerful 1200W motor for rapid stock removalVariable speed control improves versatility when working with different workpiecesSide dust port connects to the supplied dust bag or dust extraction systemBelt tracking adjustment for accurate alignment of the sanding beltRubber over-moulded grip offers increased support, safety & control of the toolLock-on button adds convenience with extended useSmall diameter front roller allows for sanding in confined areasPower-on neon increases operator safetyRemovable bail handle increases support & safetyEasy access brushes allows changing of worn brushes
Once attached to a bench or fixture, this clamp works great as a quick-action hold down for jigs or as a simple way to secure a work piece. Its holding capacity is approximately 200 pounds.Bottom of rubber foot adjusts from 1/4" above mounting surface to 3/8" below mounting surface. Total length with arm extended and T-handle up is 2-5/8". Height is 2-1/4".Mounting plate is 1-9/16" W x 1" L.Does not include mounting screws.
This jig allows you to rip thin strips on the left side of the blade, eliminating the danger of pushing narrow strips between the saw and fence. Since the strip is not trapped between the blade and fence, there is also less risk of binding and kickback. It's simple to use; a single knob locks the jig into the miter track and locks your setting at the same time. Ball bearing guide keeps your workpiece firmly against the fence for perfect repeatability. Use the graduated scale to fine-tune for extremely thin strips. Note: Ripping thin strips requires the use of a zero-clearance insert, sold separately.The perfect tool for edging, inlay, bent laminations and more.Solid phenolic for durability.Low-profile miter track clamp locks in at any point along the miter track.Also works great on the bandsaw as a single-point fence for cutting curved slats in multiples.Adjusts from 1-3/8" away from your miter track to 5-11/16" away from your miter track, enough for the thinnest ripsMeasures 5-1/4"W x 8"L.The jig is stationary, while the fence is moved for each cut.Fits 3/4" W x 3/8" D Miter Tracks