Rockler Inline Stop for Rockler T-Track System

Combined with your T-Track Table, these stops give you a fast, accurate work holding solution for a wide variety of applications. The stops feature low-profile knobs that fold flat for easy clearance when sanding or machining. Inline Stops are useful when you want to sandwich a board between two stops so you can scrape, sand or plane in either direction. If you need light clamping pressure, tap a pair of carpenter's shims between one of the stops and you have a very secure holding system for light routing tasks or carving. The keyway on the bottom of the Inline Stop runs perpendicular to the stop face. Two other stop styles are available separately: Short and Long (both with keyways parallel to stop face).

$6.99
Buy
 

Related Products

Small T-Handle Clamp

Small T-Handle Clamp
$16.99

Once attached to a bench or fixture, this clamp works great as a quick-action hold down for jigs or as a simple way to secure a work piece. Its holding capacity is approximately 200 pounds.Bottom of rubber foot adjusts from 1/4" above mounting surface to 3/8" below mounting surface. Total length with arm extended and T-handle up is 2-5/8". Height is 2-1/4".Mounting plate is 1-9/16" W x 1" L.Does not include mounting screws.

Rockler Pen Press Drilling Jig with 10 Free Plateau Fountain Pen Hardware Kits

Rockler Pen Press Drilling Jig with 10 Free Plateau Fountain Pen Hardware Kits
$159.89

Drill and assemble your pens perfectly with flush fittings and a smoothly-operating mechanism! This dual-purpose jig takes care of both prep work and assembly. It holds your blank firmly in position for drilling, creating a precise, perfectly centered hole the entire length of the pen. Later, it smoothly presses your parts together without any bowing or misalignment. Notched jaws automatically center the blank for drilling, while two countersunk holes center the parts during assembly. Large clamping wheel provides slow, controlled pressure so you'll never crack a casing again.

Rockler Pock-it Hole Clamp with Quick Release

Rockler Pock-it Hole Clamp with Quick Release
$21.99

The Pock-it Hole Clamp with a new Quick Release features a unique design that inserts a built-in adjustable pin into a 3/8" x 15° pocket hole, giving you perfect alignment every time. Now setups are even quicker and easier with the new quick-release slide button to snug up your fit, then use the ratcheting handle for final tightening. The clamp has all the clearance you need to clamp and fasten double joints in one easy step. Simply clamp the joint using one hole, then insert a screw in the other hole and tighten. Works perfectly with 3/8" pocket holes on 3/4" thick face frames and casework, and stock up to 3" wide.Unique design allows easy clamping and surface alignment of pocket hole jointsThe adjustable pin fits in a 3/8" x 15° pocket hole while the clamp tightens the joint Works in 3/8" pocket holes on 3/4" thick face frames and caseworkClearance in the clamp body enables clamping and fastening of double joints in one easy step Ratcheting handle allows for clamping face frames flat on the workbenchTighten or release the handle quickly and easily using the new quick-release slide button 3" wide stock capacity