Mixers are extremely helpful but can also be extremely heavy. They can also take up much needed space if left out on the counter making it necessary to lift and put away the mixer only to have to lift it back out again later. The Heavy-Duty Mixer Lift from Rev-a-Shelf allows you to easily raise your mixer (holds up to 60lbs) out of its cabinet to counter-top level. This gives you easy access to your mixer in seconds without having to lift such a heavy appliance. To lift your mixer gently pull it up and fix it into position by sliding the lock back. When you are ready to put your mixer away all you need to do is pull the lock out and gently slide the mixer back into the cabinet. Rev-a-Shelf's heavy-duty mixer features built-in shock dampers which allow for a smooth movement when going up or down. This lift also features an adjustable spring tension mechanism which helps ease the effort of lifting or lowering the mixer. The mixer lift can be adjusted to several different weight capacities: 0-20lbs, 20-30lbs and 30-60lbs.Cabinet Requirements Cabinet Depth: 24 Minimum Cabinet Height: Full height with no drawer To help determine the width of your shelf install the mounting plates and then measure the distance between them minus 1-1/4 Cabinet Frame Opening: 12-1/2 Minimum Shelf Size: ¾ thick x 20-1/2 length MinimumMixer Limitations Weight: 60lb Maximum Height: 17-9/16 Maximum
With jaws that stay perfectly parallel, these clamps are ideal for accurate clamping of casework and drawers. The unique handle doubles as a clutch - just pull up to disengage. Clutch prevents clamp head from sliding down and pinching your fingers while on the clamp rack. The bar has no serrations, so the jaws slide smoothly and dried glue flakes off easily. Non-marring jaws are a full 2" in width to spread clamping pressure over a greater surface area. Extra long screw thread gives a long clamping reach. Removable foot allows you to reverse the head for use as a spreader. 3-3/4" throat depth. For better alignment, see our Rockler Parallel Clamp Blocks. The unique design guarantees parallel alignment for strong, solid holds.
Economical and versatile, these adjustable slide glides are designed for use with cabinet drawer openings that have a center, T-shaped guide rail. The set consists of one adjustable center-mount plastic backplate and two L-shaped nail-on glides for drawer edges. Backplate adjusts to fit guide rails from 1" to 1-7/16" wide.Technical DetailsUse for new projects or as retrofit slides for cabinets with wooden center guide railsAdjusts to drawer guide rails from 1" to 1 - 7/16" wide in 1/16" incrementsIncludes two side-mount plastic glides for drawer edgesSelf-lubricating plastic
Prevent tools from sliding around and becoming damaged in your tool box. This nonslip liner is solid grade and cushioned to keep tools in place even as you slide tool box drawers in and out, avoiding scratching and marring. Anti corrosive Rust Gard coating will inhibit rust and protect your tools for up to five years. Comes in a 22" x 6' roll that can easily be cut to size and installed without adhesive. Washable.