Dust Right Separator Hose Holder

Woodworkers have embraced the Dust Right Separator, but storing the Expandable Dust Right Hose can be tricky. Now you can take full advantage of that hose's incredible shrinking potential with the Hose Holder for the Dust Right Separator! Simply slip the hose over the rod, and what was once a 12' hose falls into a compact stack like a Slinky. Roll it safely into a corner to await its next job. The Hose Holder for the Dust Right Separator features an integral caster to support the weight of the hose, and to prevent tipping. Designed to work with our Shop-Vac Hose Kit with Expandable Hose (32989, sold separately).Features:Metal bracket fastens easily with screws to the lip at the bottom of the Dust Right Separator.Venting on bracket prevents strain on the vacuum motor in the event that it's turned on while the hose is in storage

$24.99
Buy
 

Related Products

iVac Pro 4'' Blast Gate Starter Pack

iVac Pro 4'' Blast Gate Starter Pack
$239.99

This electronically driven automatic blast gate system is an optional upgrade to the iVac Pro Wireless Dust Collection Control System, bringing one-touch simplicity to managing your dust collection airflow. Simply turn on your power tool, and the iVac Pro Tool (42891, sold separately) sends a wireless signal to automatically open the corresponding Pro Blast Gate, and another signal to the iVac Pro Switch (42897, sold separately), which turns on your dust collector. Turn off your power tool, and after a short interval to clear dust, the blast gate closes and the dust collector powers down. This automation prevents the irritating dust clouds that result from forgetting to open a blast gate, and the reduced suction that results from forgetting to close it afterward. The system also ensures that at least one gate stays open when the vacuum is on to prevent overloading the motor on your dust collector. Prevents the irritating dust clouds you get from forgetting to open the blast gateReduces the potential for accidents from reaching for blast gates while machines are runningOptimizes the suction in your system by keeping a minimum number of gates open at one timeBlast gates can also be controlled via the handheld wireless remote or manually with the toggle switchKit includes two blast gates for 4'' hose, two 115v AC adapters, a wireless remote control and a manual toggle switchUp to eight blast gates can operate on one systemAdditional blast gates available separately (52504)RF range: 40'

Rockler Dust Collector for Rockler Dovetail Jigs

Rockler Dust Collector for Rockler Dovetail Jigs
$47.99

Finally, an affordable dust collection attachment for your Rockler dovetail jig! You don't have to spend hundreds of dollars to get dust collection with a dovetail jig. Our revolutionary new dust collector eliminates virtually all the dust created when cutting dovetails. It easily attaches to Rockler's dovetail jigs (both new and old!) and a shop vacuum or dust collection system to provide you with a clean cutting area and safe working conditions.Easily attaches to Rockler's dovetail jigs Built-in 2-1/4" port fits most shop vac hoses (not included).Sliding baffle directs the dust collection to where the dovetails are being cut.Sweep brush adjusts to provide a complete seal for stock thicknesses of 1/2" up to 1-1/8".Contains the dust while allowing the bit to travel through without damage.Two extra long 4" knob posts make adding your dust collector shroud easy.Built-in 2-1/4" port fits most shop vac hoses (not included).For older Rockler dovetail jigs with 4-screw side stops, conversion kit #25174 is required. (Sold out and no longer available).Patent pending.

Elbow Connector Dust Collection Fittings

Elbow Connector Dust Collection Fittings
$4.99

Elbows are necessary whenever ductwork changes direction, such as, from the dust collector to an overhead mainline and when connecting individual machines to branch lines.Available for both 2-1/2" and 4" hose.