This Tool Pouch acts much like a compact, lightweight tool tote, but unlike a tote, it doesn't take up space on your benchtop. Instead, it slips onto the included 8" Clip Rail, which is attached to the side of your bench, work table, or to the wall. If desired, additional Clip Rails can be purchased to provide parking spaces for the Tool Pouch as you move from work station to work station. The pouch is compact, lightweight, and it keeps your most commonly used tools and hardware visible and within easy reach. Two large pockets provide space for screws and other fasteners while nine narrower slots accommodate drill bits, drivers, pencils, rulers and more.Technical Details:Made of durable polyester fabric.Two steel clips allow mounting onto the included 8-inch Clip Rail.Also can be used with the 16-inch Clip Rail (43875, sold separately).Reinforced with a backer board for rigidity.
Available in lengths ranging from 3/8" to 1-1/4", these solid brass wood screws are well-suited for a range of woodworking tasks. They have a flat-head design that allows them to sit flush with the surface once installed, and the Phillips heads are highly resistant to stripping.Technical Details:Solid brass for a perfect match with other brass hardware.Sits flush with surface once installed.Brass screws are soft - be sure to drill a pilot hole to prevent breakage.
The Pock-it Hole Clamp with a new Quick Release features a unique design that inserts a built-in adjustable pin into a 3/8" x 15° pocket hole, giving you perfect alignment every time. Now setups are even quicker and easier with the new quick-release slide button to snug up your fit, then use the ratcheting handle for final tightening. The clamp has all the clearance you need to clamp and fasten double joints in one easy step. Simply clamp the joint using one hole, then insert a screw in the other hole and tighten. Works perfectly with 3/8" pocket holes on 3/4" thick face frames and casework, and stock up to 3" wide.Unique design allows easy clamping and surface alignment of pocket hole jointsThe adjustable pin fits in a 3/8" x 15° pocket hole while the clamp tightens the joint Works in 3/8" pocket holes on 3/4" thick face frames and caseworkClearance in the clamp body enables clamping and fastening of double joints in one easy step Ratcheting handle allows for clamping face frames flat on the workbenchTighten or release the handle quickly and easily using the new quick-release slide button 3" wide stock capacity
Put an end to screws that dive below the surface and leave an ugly chipped out hole—PowerHead screws feature a broad, flat head that simply won't pull through. The 9/16'' diameter head offers superior holding power and is perfectly sized for a FastCap screw cap. Plus, when used with an impact driver, the cutting nibs on the underside of the head shear away material till the head sits perfectly flush. 9/16'' diameter heads won't pull throughSelf-tapping tips#10 Screws