Each piece is precisely shaped, sanded and ready for finishing. All come in 8' lengths.
This thin kerf industrial blade provides a superior finish cut with sliding compound miter saws. The 5° negative hook angle helps prevent the blade from being too aggressive and pushes the work piece down and towards the fence. Thin kerf blades remove less material than standard carbide blades, thus requiring less horsepower to produce equally good results.The Perma-SHIELD coating covers the blade plate and cutting edge in a protective layer, reducing heat build-up. Perma-SHIELD blades resist binding in large volume cutting, reducing subsequent blade warp. The coating lubricates the blade, allowing it to spin freely, and eliminates pitch and debris build-up on the blade.Also available with the economical Silver I.C.E coating.
This is without a doubt one of the finest pens a deer-hunting enthusiast could hope to make or receive as a gift. The lower barrel features a relief cut engraving of a trophy buck that emulates the engraved scrollwork found on genuine, highly sought after bolt-action rifles. The antiqued plating provides contrast for better visibility of the details. At the other end, a deer mount pen clip with a scope at the tip of the clip rounds out the deer hunting theme. The body and bolt-action mechanism are the same as those on the popular Bolt-Action pen kits and use the same accessories. The antique finish is formulated to simulate a time-worn authentic patina with a charm all its own, adding a sense of warmth and history to your handmade writing instrument.
This easy, durable, non-toxic oil finish has been approved safe for toys! A blend of high quality oils, resins and dryers, Liberon Finishing Oil resists water, heat, alcohol and food acids, making it ideal for kitchens, bathrooms and other high-use areas. Beautiful matte/satin sheen does not obscure the grain, and highlights the natural beauty of the wood. Dries in about 5 hours. Made in England. Available in 250 ml or Liter size.For interior use.1 liter covers 32-39 sq. ft.Apply with a brush or cloth.Allow oil to penetrate up to 10 minutes, and wipe off all excess with a clean cloth before the surface gets sticky.Allow at least 5 hours dry time, then apply more coats as required.For best results, gently rub with Extra Fine Steel Wool between coats.To avoid fire hazards, allow all oily cloths to dry thoroughly outside before discarding.Clean up tools with mineral spirits.May also be used on cork, stone and terracotta.Finishing Oil may darken some woods.Please note that this item can only be shipped by UPS Ground to addresses within the continental United States.