These quality carvings come ready to finish. Choose from Birch or Oak. Measures 4-1/4" High x 14-1/4" Wide.
This 15" flat pry bar features a black oxide finish for protection against rust and corrosion, and is manufactured from heat treated steel for maximum strength. It features three nail pullers for working fasteners loose from virtually any angle, and one of the pullers also doubles as a hang hole. A great size for the shop or jobsite, the pry bar is just as invaluable tool for careful lifting and prying, as well as it is for all out demolition.Technical Details:Prybar features a black oxide finish for corrosion resistance.Heat treated steel for maximum strength.Prybar measures 15" long for optimum leverage.Three nail pullers for access from almost any angle.
With deluxe post-plated finishes and end-to-end support, these piano hinges combine flawless appearance with unwavering stability, making them perfect for a wide range of applications. Countersunk screw holes every 2" ensure maximum strength, while slotted holes at both ends allow for simple installation and alignment. And since the rich charcoal gray finish is applied at the end of production, there is minimal risk of marring during fabrication. Several sizes available from 36" to 72" long. Listed dimensions refer to length of barrel x open width.
Here's a fun, fast project for wood turners who also appreciate things straight, flat and square. Plumb Bobbles miniature plumb bobs are primarily decorative, but you can also string them up to work just like their bigger brothers. A long necklace cord is included for use as a necklace, and they make nice Christmas tree ornaments using the included loop of nylon cord. A mandrel (48782, sold separately) with bushings integrated is required for chucking it onto your lathe. 10K gold plating.Includes a short length of nylon cord, and a necklace cord. Finished Plumb Bobble can range in length from approximately 1-7/8" to 2-1/4" long.Width of hardware is 3/8".A mandrel (48782, sold separately) with bushings integrated is required for chucking it onto your lathe.