The foolproof finishing system! Just wipe on with a clean cloth and you're ensured of professional quality results without brush marks. Stains dry to the touch in minutes. If you want a darker color, apply another coat of stain in only 6 hours. Once you're satisfied with the color, apply General Finishes's satin gel topcoat finish. Special formula repels dust between coats. No sanding needed between coats and no unpleasant smell.Note:Coded as a flammable substance by the U.S. Department of Transportation. Can not be shipped by air or through the postal systemHow To Apply the Oil Base Gel StainApplying the gel stain is a simpler process than traditional stains that require sanding between coats. Before you apply your stain however you should prep your piece to ensure the stain covers correctly. Clean the surface you plan to stain Sand the surface. The suggested grit is 120-150 grit, you want to make sure that any existing finish that might be peeling is removed so the stain applies to the actual project surface. Apply the gel stain liberally with either a cotton cloth, natural bristle brush or a poly foam brush. (Be sure to test a small area of your project to make sure it is the finish you want and that the application method you've chosen is working well for you.) Wipe off the gel stain going with the grain using a clean dry cotton cloth or high quality paper towels. Let it dry, between coats give you project a chance to dry. Drying time varies based on the size and nature of your project as well as the environment it's located in. Normally drying time ranges from 6 to 12 hours. Repeat Steps 3-5 IF you want more coverage or you want a deeper/richer finish.Suggested TopcoatTopcoat can be used as a sealer over paints and stains or as a clean finish. If you want to use a top coat the recommended topcoat is Oil Based Arm-R-Seal Urethane Topcoat (sold separately).
When the time comes to finish off the bottom side of your bowl, this adapter helps you quickly flip and rechuck the bowl without the fussy alignment/truing process. Simply remove your Nova chuck with the bowl still mounted in it, and using the Nova Tailstock Chuck Adapter, install both onto the tailstock Live Center System (44550, sold separately). Slide the tailstock up to the headstock and rechuck the bowl onto the headstock with your preferred method (Longworth chuck, vacuum chuck, Cole jaws etc). The bowl will be perfectly centered, and ready for the finishing touches.Allows for perfect alignment when remounting work to turn the bottom side, saving you the time and material normally wasted in truing the workpiece up.Ensures the most accurate remounting of projects.Use with the Nova Live Center System (44550, sold separately) - or use alone as a dead center.In live mode, the Tailstock Chuck Adapter can be used to support work with a chuck e.g. in conjunction with vacuum chucking. #2 morse taper fits all Nova chucks and Nova lathe tailstocks.Made from medium tensile carbon K1045 steel to provide maximum structural strength.1-1/4" 8-TPI RH thread (USA, Canada, Australasia and the UK). 2 year warranty
Craft your own wooden dominoes from any species of wood! Makes an excellent gift that'll have people "lining up" at the table for some fun and games. Simply use the included bit and templates to drill the "spots" in your blank, then cut out your dominoes. The guide notches provide easy reference for cutting accuracy.Two templates makes one full set of double-six dominoes (28 tiles).Includes two drilling templates and a spring-loaded, hex-shank Domino Drill Bit.Finished tiles measure approximately 1" x 2".Templates measure 4-3/8" x 10".