Hot-Melt Edge Bandings “ 250' Rolls

An ordinary household iron is all you need to apply this premium hot-melt edge banding. Just position the edging on the edge of your plywood or other substrate and smooth it with a few passes of an iron or slide it through an edge-banding machine. Suitable for straight-line edges as well as contours. Bandings are impregnated with a high-speed hot-melt glue that creates a permanent bond. They also are pre-sanded and readily accept stains and finishes. Both solid wood edge bandings and melamine edge bandings are available.Features:Wood edging is made of solid hardwood veneer.Available in a variety of wood species some of them difficult to find in edge bandings.

$30.99
Buy
 

Related Products

Gel Stain - General Finishes - Nutmeg

Gel Stain - General Finishes - Nutmeg
$9.99

The foolproof finishing system! Just wipe on with a clean cloth and you're ensured of professional quality results without brush marks. Stains dry to the touch in minutes. If you want a darker color, apply another coat of stain in only 6 hours. Once you're satisfied with the color, apply General Finishes's satin gel topcoat finish. Special formula repels dust between coats. No sanding needed between coats and no unpleasant smell.Note:Coded as a flammable substance by the U.S. Department of Transportation. Can not be shipped by air or through the postal systemHow To Apply the Oil Base Gel StainApplying the gel stain is a simpler process than traditional stains that require sanding between coats. Before you apply your stain however you should prep your piece to ensure the stain covers correctly. Clean the surface you plan to stain Sand the surface. The suggested grit is 120-150 grit, you want to make sure that any existing finish that might be peeling is removed so the stain applies to the actual project surface. Apply the gel stain liberally with either a cotton cloth, natural bristle brush or a poly foam brush. (Be sure to test a small area of your project to make sure it is the finish you want and that the application method you've chosen is working well for you.) Wipe off the gel stain going with the grain using a clean dry cotton cloth or high quality paper towels. Let it dry, between coats give you project a chance to dry. Drying time varies based on the size and nature of your project as well as the environment it's located in. Normally drying time ranges from 6 to 12 hours. Repeat Steps 3-5 IF you want more coverage or you want a deeper/richer finish.Suggested TopcoatTopcoat can be used as a sealer over paints and stains or as a clean finish. If you want to use a top coat the recommended topcoat is Oil Based Arm-R-Seal Urethane Topcoat (sold separately).

4" x 24" Aluminum Oxide Belts

4" x 24" Aluminum Oxide Belts
$4.49

Resin-on-resin bonded aluminum oxide sanding belts are perfect for the toughest wood sanding jobs. The belts feature a heavy duty 100% cotton backing for increased working life. All belts are open coat, preferred for sanding off painted or finished surfaces as the belts resist "loading up" with removed material.Technical Details:4" wide x 24" circumferenceResin-on-resin bonded aluminum oxideAvailable in 60, 80, 100, and 120 gritsOpen coat - resists cloggingHeavy duty 100% cotton backing

Bendix Hand Carved Papyrus Capitals-Maple

Bendix Hand Carved Papyrus Capitals-Maple
$29.99

These hand carved Maple capitals will make a fine finish for your project. Each piece is precisely shaped, sanded and ready for finishing.