Jet Spray Blush Eraser

Having problems with your finish turning hazy, or white? No need to sand or strip, just spray on a coat of Blush Eraser. "Blushing" is caused by humidity and cold weather, so if you work in a humid, damp, or cold climate, keep a can of this on hand. This amazing product re-flows the lacquer and allows the trapped moisture to escape without changing the existing sheen or shade of color. 13 fl. oz.For best results, use when air temperature is between 65-90° F.Apply several thin coats.Extremely flammable.Please note that this item can only be shipped by UPS Ground to addresses within the continental United States.

$10.99
Buy
 

Related Products

Rockler Stainless Steel Pizza Cutter Turning Kit, Pewter Finish

Rockler Stainless Steel Pizza Cutter Turning Kit, Pewter Finish
$19.99

Cut any pizza with ease-a must-have for pizza lovers! Robust, well-balanced hardware is 3X the weight of competing cutters and features a sharp 4'' diameter stainless steel blade. Just add your own custom handle (not included) to top it to your taste. Kit includes a 5/16'' threaded insert that lets you attach the handle or remove it for dishwasher cleaning. A 7/16'' drill bit is required for soft woods or a 1/2'' drill bit for hardwoods. Patent pending. Also available in brass or chrome. See our complete line of turning stock to turn the handle for your pizza cutter. Methods to consider for installing the threaded insert: Use a 5/16'' bolt and double nuts on a drill press. Cut the head off a 5/16'' bolt and chuck it in a drill press. Then thread on two nuts and the insert so that it is flush with the end of the bolt. Tighten the two nuts on the insert so it won't spin on the bolt. After the pilot hole is drilled in the stock, clamp your stock with a handscrew or a drill press vise and manually turn the drill press chuck to drive the insert into the stock. DO NOT TURN ON THE DRILL PRESS. The drill press will keep the insert square to the stock as it is threaded in. We also recommend using beeswax, screw lube, or even soap to lubricate the threads on the insert. This process can also be done on a lathe using a three jaw chuck in the tailstock to manually feed the insert into the stock. Finally, if you're using acrylics for your handle, we have found that heating the insert before installing it makes it go in like a hot knife in butter.

Micro Mesh 3" X 6" 6000

Micro Mesh 3" X 6" 6000
$4.49

Micro-Mesh is used to polish surfaces back to clarity or a high gloss. Available in grades 1500-12,000.Micro-Mesh (Grades 1500 through 12000) was originally designed to polish most hard plastics, fiberglass, epoxy, gel-coat, raw and finished wood, cultured marble, sold surface, painted surfaces, gold, silver, etc. Micro-Mesh is not an aggressive stock remover. Common sandpaper products are required for the removal of deep scratches prior to using Micro-Mesh to polish the surface back to clarity or a high gloss. Use wet or dry with either water or water/detergent as a lubricant. You may also use mineral oil, vegetable oil, lemon oil, etc but DO NOT use anything containing solvent as this will delaminate the MICRO-MESH. Sheets are offered in the following Micro-Mesh grades: 1500, 1800, 2400, 3200, 3600, 4000, 6000, 8000, 12000

Bendix Acanthus Claw Legs

Bendix Acanthus Claw Legs
$44.99

A classic motif for a variety of furniture and cabinetry. Each piece is precisely shaped, sanded and ready for finishing. Acanthus Claw Leg measures 8"H x 4-1/2"W x 4-1/2"D.