Commonly called "campaign hardware", this line of gorgeous recessed brass hardware serves both to beautify and to protect your furniture and surrounding items. The term "campaign hardware" derives from the 18th and 19th centuries, when English officers demanded high-quality, portable furniture while on military marches. The recessed hardware and brass corners allowed furniture to nestle together in a compact stack, and prevented scratches while stowed in the back of a bumpy horse-drawn wagon. Once unpacked and in the tent, however, the furniture served as a beautiful reminder of home.Technical Details:Solid brass recessed drawer pull.Polished finish.Dimensions: 3-5/8"W x 2"H.Total depth: 1/2"Projection from surface (if surface-mounted): approximately 1/8".Can be surface-mounted or mortised flush with the surface.Sold singly.Installation and Care Instructions:Measure and mark hole fixings with a pencil, preferably onto a strip of masking tape that will help to steady the drill.Drill a pilot hole as a lead for the wood screw.Remember, the included wood screws are made of brass so never overtighten or attempt to drive without a pilot hole, as this can cause them to break off in the wood.Occasional use of a damp cloth, and the use of quality wax polish is recommended to maintain the lustre.
Tightening Rockler's new Auto-Lock T-Track Hold Down Clamp is literally an open-and-shut case-just press down the lever to secure anything from veneer sheets to lumber up to 2-3/4'' thick! Once set, the clamping pressure is always the same regardless of workpiece size, and is adjusted only if needed with the set screw. The clamp pivots 360°, allowing you to clamp near the workpiece edge to minimize obstructions. A large knurled wheel locks the clamp securely to the T-track. The toggle foot is adjusted with the knurled aluminum knob for best placement-no wrenches required-while the clamping foot pivots on a ball joint so it can adapt to any angle and is rubber coated to prevent marring. Simply lift the lever to release. Auto-adjust mechanism allows you to clamp various thicknesses without readjustingCenter of clamping foot extends from 1-1/2'' to 3-1/2'' from center of trackMax height capacity is 2-3/4''Clamping force is adjustable from 5-250 lbs of pressureLarge locking wheel secures clamp to T-trackClamps slide into any T-track that accepts 5/16'' T-bolts, including our T-Track Table (46654, sold separately) and many of the CNC Shark tablesAn optional Mounting Bracket (57940) is available for securing the clamp to shop-made jigs and fixturesHeavy-duty metal construction
Finish: Brushed Antique CopperBase Material: BRASSLength: 3-3/4 InchesWidth: 9/16 InchProjection: 1-3/16 InchesCenter to Center Hole Spacing: 3 InchesBase Diameter: 3/8 InchMachine Screw Thread Size: 8-32Screw Length: 1 InchPilot Hole Size: 3/16 InchScrews are includedWarranty: Lifetime