Knob/Pull Machine Screws-8-32 Screws

Standard #8-32 machine screw, used for drawer front knobs and pulls.Different length screws used for installing pulls and knobs. Truss head design has a flatter profile than a regular round head screw. Zinc plated.

$2.99
Buy
 

Related Products

Edge Banding Machine

Edge Banding Machine
$319.99

Discover why the pros use this edge banding machine! Allows you to easily apply hot-melt adhesive-backed edge banding to straight edges.Techincal Details:Electronically controlled heating element is infinitely adjustable from 200° to 1100°.120 volts, 1500 watts. Rear-mounted on/off switch and top-mounted heat control dial allow use of a wider variety of edge-banding materials.Light, durable construction and adjustable, non-skid rubber feet. Built-in cut-off knife has a palm-strike knob. All fences and guides adjust using the same Allen wrench. Laminate-covered table is 27" by 7-1/2". Maximum material thickness is 2".

Rockler Short Stop for Rockler T-Track System

Rockler Short Stop for Rockler T-Track System
$6.99

Combined with your T-Track Table, these stops give you a fast, accurate work holding solution for a wide variety of applications. The stops feature low-profile knobs that fold flat for easy clearance when sanding or machining. Short Stops can be used on one end of the board to hold your work while belt sanding, hand planing, or scraping dried glue off of a panel. The keyway on the bottom of the Short Stop runs parallel to the stop face. Two other stop styles are available separately: Inline (with keyway perpendicular to stop face) and Long (keyway parallel to stop face).

Century Solid Brass, Knob, 1-1/4'' dia. Polished Brass, 12816-3

Century Solid Brass, Knob, 1-1/4'' dia. Polished Brass, 12816-3
$7.99

Century Solid Brass, Knob, 1-1/4" dia. Polished Brass, 12816-3Diameter: 1-1/4"Projection: 1"Screws are included