Replacement Kreg Klamp Blocks with T-Bolts and Knobs, 5-Pack

Position these adjustable Klamp Blocks on the Kreg Klamp Table (36078, sold separately) to quickly square up frame parts for connecting with pocket-hole joinery. Package of 5 Klamp Blocks with T-bolts and knobs for mounting.

$15.99
Buy
 

Related Products

Berenson Newport Pull 4992-3BAC-P

Berenson Newport Pull 4992-3BAC-P
$15.79

Finish: Brushed Antique CopperBase Material: BRASSLength: 3-3/4 InchesWidth: 9/16 InchProjection: 1-3/16 InchesCenter to Center Hole Spacing: 3 InchesBase Diameter: 3/8 InchMachine Screw Thread Size: 8-32Screw Length: 1 InchPilot Hole Size: 3/16 InchScrews are includedWarranty: Lifetime

Amerock Village Classics Knob, BP19321-FB

Amerock Village Classics Knob, BP19321-FB
$6.69

Finish: Flat BlackBase Material: ZincDia.: 2-9/16 inchLength: 2-9/16 inchWidth: 7/8 inchProjection: 1-1/2 inchMachine Screw Thread Size: 1 x #8 32 x 1 inchScrews are includedWarranty: Lifetime

Auto-Lock T-Track Hold Down Clamp

Auto-Lock T-Track Hold Down Clamp
$29.99

Tightening Rockler's new Auto-Lock T-Track Hold Down Clamp is literally an open-and-shut case-just press down the lever to secure anything from veneer sheets to lumber up to 2-3/4'' thick! Once set, the clamping pressure is always the same regardless of workpiece size, and is adjusted only if needed with the set screw. The clamp pivots 360°, allowing you to clamp near the workpiece edge to minimize obstructions. A large knurled wheel locks the clamp securely to the T-track. The toggle foot is adjusted with the knurled aluminum knob for best placement-no wrenches required-while the clamping foot pivots on a ball joint so it can adapt to any angle and is rubber coated to prevent marring. Simply lift the lever to release. Auto-adjust mechanism allows you to clamp various thicknesses without readjustingCenter of clamping foot extends from 1-1/2'' to 3-1/2'' from center of trackMax height capacity is 2-3/4''Clamping force is adjustable from 5-250 lbs of pressureLarge locking wheel secures clamp to T-trackClamps slide into any T-track that accepts 5/16'' T-bolts, including our T-Track Table (46654, sold separately) and many of the CNC Shark tablesAn optional Mounting Bracket (57940) is available for securing the clamp to shop-made jigs and fixturesHeavy-duty metal construction