Replace your traditional spur drive with the Revolutionary Robert Sorby Stebcentre Morse Taper! An essential addition to every turner's toolkit, it incorporates a spring loaded point in stainless steel and a set of razor sharp teeth that bite into the workpiece. Provides added security for the novice turner by allowing you to vary the degree of bite to the point where kick back of the turning chisel is eliminated. The Stebcentre may also be removed without the need to stop and re-start the lathe. Simply wind back the tail stock and the piece can be withdrawn safely.Size refers to drive face diameter. Comes in diameters of 1/2", 7/8", and 1-1/4". Made in England.Technical Details:Replaces traditional spur drivesIncorporates a spring loaded point in stainless steel and a set of razor sharp teeth that bite into the workpieceLets you vary the degree of bite to the point where kick back of the turning chisel is eliminatedMay be removed without the need to stop and re-start the latheSize refers to drive face diameterComes in diameters of 1/2", 7/8", and 1-1/4"Made in England
This is the standard live center included with all Nova lathes—use as a replacement or as an upgrade for another lathe. With heavy-duty sealed bearings, precisely machined medium tensile carbon steel construction, and a solid steel point to dig into the wood blank, the center provides a long useful life, and solid workholding capabilities. The #2 morse taper fits most brands, but check the manual for your specific lathe to find the morse taper size. 2MT Center, suitable for all lathes with a #2 morse taper tailstock.Heavy-duty sealed ball bearings for long life.Steel point for a solid bite into the turning blank.Precisely machined medium tensile carbon steel.Standard equipment on all Nova lathes.
This key ring hardware kit features gold-plated exterior trim hardware and includes all necessary hardware. Key ring fits standard 7mm mandrel shaft and uses a 7 mm drill bit. Wood blank not included.Pen Turning Mandrel System This is the essential tool for pen turning on a lathe! Machined-accurate steel bar is held in the lathe to ensure the pen turns accurately with live center, no drill chuck required! This Pen Turning Mandrel system includes a #2 morse taper arbor for use with #2 morse taper lathe, mandrel shaft and knurled nut. #1 morse taper arbor attaches to mandrel (#23552) for use with #1 morse taper lathe. 10mm mandrel for use with fountain and rollerball pen bushings. Bushing sets sold separately.