1'' Round Knob for Shop Jigs

These 1" Round Knobs with Bolt are 1/4 20 tpi and are ideal for jigs, router tables, drill presses and other similar applications. Length of bolt is 1''. They work great with our T-Slot System.

$1.99
Buy
 

Related Products

Rockler Roundover/ Beading Router Bits - 1/2" Shank

Rockler Roundover/ Beading Router Bits - 1/2" Shank
$22.99

With two included bearings-one flush for a standard round over, and one slightly smaller for a beaded edge-these combination bits make versatile workhorses that will see plenty of use in your shop. Among our most popular router bit choices, they're perfect for making edges softer, both to the touch as well as to the eye. For a bit more definition, just switch the bearing to the beading mode. Shear angle provides the smoothest cut available.Includes smaller 3/8" bearing and wrench for beading applications at no additional charge.Items with * in the description are larger bits that should be used in router tables at reduced RPM.Two flutes.1/2" bearing pre-installed.1/2" shank for minimal vibration.

Rockler Table Top Edge Router Bit - 2-1/2" Dia x 25/32" H x 1/2" Shank

Rockler Table Top Edge Router Bit - 2-1/2" Dia x 25/32" H x 1/2" Shank
$79.99

With it's generous 2-1/2" diameter, this edge profiling bit works beautifully for table tops, cabinet tops and built-up moldings. The broad round over tapers toward the edge, resulting in a lighter, less bulky look. You can profile either the bottom side or the top side of your panel to achieve different visual effects.

Rockler Undersized Straight Router Bits - 1/4" Shank

Rockler Undersized Straight Router Bits - 1/4" Shank
$13.99

These straight bits are slightly undersized to cut tight-fitting grooves and dadoes for plywood that is thinner than its stated nominal thickness, which applies to most plywood and veneered MDF. Typical straight bits leave an unsightly gap when used for plywood joinery. Use these bits to cut grooves, dadoes and rabbets. Of course, they can also be used for general purpose material removal or any application which requires a flat, finished bottom. The two-flute cutters give a smooth finish with a medium feed rate. Two flutes, 1/4" shank.