Freud 97-150 3-Pc. Door Router Bit Set - 5/8" H x 1/2" Shank

Set contains Premier Adjustable Quarter Round Rail and Stile Bits to mill tenons of any length! Simply remove the top portion of the cutter (including bearing and spindle) to produce the front of the long tenon profile for blind tenons, through tenons or bridle joints. These precise bits work for any door 5/8" to 1-1/4" thick. Unique cutter geometry virtually eliminates tearout. Adjustable shims enable a tight fit when using plywood and also allow use with panels from 7/32" to 1/4" thick. High-density carbide composition and Perma-Shield coating lengthen bit life and protect against heat and pitch build-up. 1/2" shanks. Also includes a 3-1/2" dia. Bevel Raised Panel Bit.

$183.47
Buy
 

Related Products

Rockler Router Collet Extension for 1/2'' Shank Bits

Rockler Router Collet Extension for 1/2'' Shank Bits
$34.99

These collet extenders allow you to change router bits from above the table-even without a lift! Even if you have a lift, they still make bit changes easier because you won't have to remove the insert ring. They're also great for custom made router tables with very thick tops, as they provide the additional depth of cut needed for many routing tasks. Use them with our Router Table Spline Jig (59288, sold separately) to achieve full depth of cut when machining dovetail splines.

Custom Router Table Downloadable Plan

Custom Router Table Downloadable Plan
$7.95

There's no better fixture you can build or buy for your router than a router table. It turns your handheld router into a makeshift shaper and expands the range of joints and moldings you can make. There are easier paths to a router table than this one, but our design provides maximum versatility, convenience and storage space - all on wheels.

Rockler Rabbeting Router Bit Set - 1/2" Shank

Rockler Rabbeting Router Bit Set - 1/2" Shank
$49.99

With a full 1" of carbide length and four interchangeable bearings, this rabbeting bit is capable of cutting in horizontally at 5/16", 3/8", 7/16" and 1/2" increments, and up to 1" vertically, infinitely adjustable with your router. The carbide is ground to a fine edge to provide the longest possible cutting life, and smooth, burn-free rabbets. It features a rugged 1/2" shank that cuts vibration for the smoothest possible cut. A hex wrench is included for swapping the bearings.