Set contains Premier Adjustable Ogee Rail and Stile Bits to mill tenons of any length! Simply remove the top portion of the cutter (including bearing and spindle) to produce the front of the long tenon profile for blind tenons, through tenons or bridle joints. These precise bits work for any door 5/8" to 1-1/4" thick. Unique cutter geometry virtually eliminates tearout. Adjustable shims enable a tight fit when using plywood and also allow use with panels as thin as 7/32". High-density carbide composition and Perma-Shield coating lengthen bit life and protect against heat and pitch build-up. 1/2" shanks. Also includes a 3-1/2" dia. Bevel Raised Panel Bit.
Cuts a simple, elegant edge for molding that will add character to any room. 1-1/4" diameter, 2-1/4" cutter length, 1/2" shank, 1-1/2" shank length.
Sometimes it's better to emphasize a seam than to try to hide it. This bit does just that, applying a neat decorative V-groove along the line of the seam. Since you no longer have to sand the joint perfectly flush as you would with a typical flush trim bit, you also cut down on a lot of sanding. Just a pass or two with a palm sander is enough to remove any mill marks. Ideal for trimming cabinet face frames flush with the cabinet sides.
The interchangeable insert for standard bits features a 2-1/2'' opening. The 4-3/8'' OD allows this insert to fit into a large plate with a 3-11/16'' opening. Fits the Following Router Lifts: Rockler Router Lift FX (23194) Bench Dog 40-150 ProLift Router Adjustment System (28827) Fits The Following Rockler Router Table Plates:Rockler Router Plate CPorter Cable 7518Porter Cable 7519Porter Cable 7538Porter Cable 7539Milwaukee 5625-20Triton TRA001Triton MOF001Rockler Router Plate DBosch 1619-1619EVFreud FT2000DeWalt 625