Mill tenons of any length! Simply remove the top portion of the cutter (including bearing and spindle) to produce the front of the long tenon profile for blind tenons, through tenons or bridle joints. These precise bits work for any door 5/8" to 1-1/4" thick. Unique cutter geometry virtually eliminates tearout. Adjustable shims enable a tight fit when using plywood and also allow use with thick panels from 7/32" to 1/4" thick. High-density carbide composition and Perma-Shield coating lengthen bit life and protect against heat and pitch build-up. 1/2" shanks.
This router clamp replaces the original clamp provided with your CNC Shark or CNC Piranha. It allows you to install the Bosch Colt Palm Router onto your Shark. Note: Not compatible with the CNC Shark HD. For an equivalent clamp that will fit the HD see 57868 (sold separately).
Intricate solid wood inlays with delicate geometric patterns. Great for adding a decorative touch to jewelry boxes, table tops, picture frames and more. Inlay bandings are easy to apply. Simply rout out a groove with a straight router bit, glue in the banding, sand lightly, and seal. Note: Dimensions are nominal and should be measured before routing the recess for installation.
This arbor includes two slotting cutters, two bearings and a pack of shims that allow you to configure and adjust the cutter for perfectly fitting tongue and groove joints. Use it to machine flat panel doors and cabinet panels, to create tongue and groove wainscoting, or just for edge joining long boards or cabinet components. The guide bearings make it easy to get a consistent depth of cut, and also allow you to machine joints for curved parts.Designed to cut a tongue and groove joint for 3/4" stock. Depth of groove is 3/8".Ball bearing guide lets you follow the material. Includes one arbor, two 22mm bearings, and two cutters.Shim pack lets you adjust the fit for the strongest glue joint.