Freud's bearing-guided mortising bits can be used with templates for perfect accuracy and repeatability. They are designed with deep center gullets for maximum material removal without chip loading. Cuts all composition materials, plywoods, hardwoods, and softwoods. Use on CNC and other automatic routers as well as hand-held and table-mounted portable routers.Features TiCo Hi-Density carbide for longer bit life and a flawless finish.Perma-SHIELD Non-stick Coating protects from heat, gumming, and corrosion.Each bit is computer-balanced and precision-ground for the smoothest possible cuts.
If you need to trim a precise amount of wood off of doors and large panels, this kit will save you a lot of tedious setups and backaches. The kit uses a razor-sharp shear-cutting bit along with different bearing combinations to remove exactly 1/16", 1/8", or 3/16" of material in just two router passes-all without a straightedge! No need to strain your back lifting and balancing a large panel on top of a jointer. Instead, you bring the tool to the material. The kit includes one carbide router bit and five bearings to set up the various depths of cut. The bit can also be used as a double-bearing flush trim bit, as two bearings are included for that purpose. Capable of trimming stock up to 1" thick. Click the "Videos" tab to see how this kit will save you time!A larger version of the same kit is available separately (26841) for trimming stock up to 2" thick.Small Bit Kit includes the following:One 3/4" diameter bit with 1" long cutter and a 1/2" shankTwo 3/4" bearings for flush trimmingThree single bearings (5/8", 1/2", and 3/8" in diameter) for trimming 1/16", 1/8", and 3/16"
Freud's exclusive Quadra-Cut Beading Bits cut a precise radius with a step on either side, the perfect combination of tactile softness and visual definition. The 4 cutter Quadra-Cut design provides the smoothest cuts possible. You'll get crisp, clean edges every time, even with cross-grain cuts in difficult materials.Beading bit applications: Create decorative bead edges.Cuts all composition materials, plywoods, hardwoods, and softwoods.Use on hand-held and table-mounted portable routers.Note: 53971-should be used with a minimum 2-1/2HP router (3HP and up is better) at a max of 12,000 RPMs.
For making signs and adding decorative accents to furniture and plaques. Freud's "V" grooving bits are designed to cut deep or shallow 90 degree "V" grooves. Cuts all composition materials, plywoods, hardwoods, and softwoods. Use on CNC and other automatic routers as well as hand-held and table-mounted portable routers.