Rout tenons with square corners easily and quickly with your Leigh FMT - the perfect solution for traditional exposed tenon joinery. This kit includes all four square tenon sizes: 1/4", 5/16", 3/8" and 1/2". These guides can rout square cornered tenons to match any mortise length up to 5". All square tenons are routed with a 1/2" router bit. Note: New FMT guides not exactly as shown.Technical Details:Includes 1/4", 5/16", 3/8" and 1/2" square tenon sizes.Routed with a 1/2" bit.
Sooner or later, a busy woodworking writer needs to get his desk organized. But what if the current desk doesn't cut it? Such was the plight of Bill Hylton, one of our regular contributors. If you're due for a new desk too, this project will give your router a good workout - and trust us - the end result will be well worth the effort.
The Triton MOF001 is a multiple award-winning plunge router with simple, intuitive adjustments and the unique capability to perform those adjustments from above the table when table-mounted. Think of it like a router with a lift built in-once mounted, just insert the winder wrench through the top of the table for precise adjustments. To change bits, just wind it all the way up. The bit extends well above the table and even automatically locks out the collet at the end of its travel. A single wrench is all you need to loosen the collet. This same ease of use extends to handheld operation. In free plunge mode, you can quickly plunge to rough depth. Rotate the handle for finer adjustments, then rotate the microadjuster for very fine adjustments. A 3-stage turret lets you immediately access commonly used depth settings. With its compact and powerful 2-1/4 HP motor and 8000-21,000 RPM variable speed with electronic speed maintenance under load, the Triton MOF001 is up to most any routing task. Includes extended base plate with fence for routing grooves and dados, plus a unique circle-cutting feature. 1/4'' and 1/2'' collets for a greater range of bit selections2-1/4 HP electronically-controlled motor for maintained speed under loadAutomatic spindle lock engages only when power switch cover is closedSoft start and variable speed for all cutter typesSingle button switches from plunge to fixed based router with rack and pinion adjustmentMicro winder enables continuous fine depth adjustment through the full plunge rangeAbove the table, single wrench bit changesElectronic speed control ensures a fine finish on all materialsRemovable plunge spring for easy bit adjustment when table mounted3-stage turret with direct reading scales for precise pre-set cut depthsFully enclosed guarding provides maximum protection from the cut zone and assists dust extractionMulti-function fence provides optimum control for hand-held use and circle cuttingQuick-fit pins for fast fitment and removal from the fence and the RTA300 Router TableSide air vents reduce intake of dust into the motor casing when mounted upside-down in a router tableExcellent dust extraction for a cleaner, safer working environmentEasy access brushes for quick changesThrough the base single-wrench bit change is achieved with the automatic spindle lockSafety switch shutter locks closed in bit-change mode to prevent router being switched on
This is the easiest, fastest way to add a drawer or shelf to your Rockler Steel Router Cabinet! The bracket holes match perfectly with the pre-tapped holes in the Router Cabinet, so installation is a breeze. Get two sets of brackets and add any combination of up to two shelves or drawers.Technical Details: Bracket holes are perfectly aligned with pre-tapped holes in the Rockler Steel Router Cabinet Rated to hold up to 100 lbs. Best Used With:Rockler Steel Router Table Cabinet (#41427 Sold Separately)