Enjoy the same speed and precision of the FMT at a fraction of the cost! The same great features produce the same great joints. Simplicity is the key. The Super FMT uses just one bit, one guide and one setup for every standard joint. It's that easy. There are no bit or guide changes to fuss with and the setup stays the same for both parts of the joint. Joint fit is easily adjusted for perfect results every time. Super FMT guides and bits allow you to create any size mortise and tenon from a tiny 1/16" x 1/8" to a massive1/2" x 5". Includes five 5/16" joint guides (5/16" by 1/2", 3/4", 1", 1-1/4" and 1-1/2"), that can make over 21 sizes of mortises and tenons.Additional features:Universal sub-base that attaches to virtually any plunge routerJoint guide stand5/16" HSS spiral upcut bit with 1/2" shank (Leigh No. 170-500)Two F-ClampsAdjustable sidestop fence for tenoning1/8" hex driverMounting hardwareIllustrated user guide
Vertical panel raising bits concentrate more of their weight toward the center of the bit, reducing strain on the motor, and allowing you to spin the bit at higher RPMs. This means you can raise panels with an ordinary 2 HP router mounted in a router table. Precision machining paired with a sturdy 1/2" shank ensure smooth, chatter-free cuts. Note: vertical panel raising bits cannot be used for cathedral-style or arched doors.
The Grr-Ripper Gravity Heel Kit provides a positive hook that grips the end of your board, ideal when you need additional support for feeding hard or heavy stock through your table saw, bandsaw or router table. The heel drops down automatically, aided only by gravity, and retracts when placed in the middle of the board. This means there's no need to remove it or adjust it when it's not needed. The Gravity Heel can also be adjusted laterally to provide backup support when you wish to prevent grain blowout of any kind. Simply saw through the heel to provide zero-clearance support. Five sacrificial heels are included, plus two heel spacers and mounting hardware. Fully adjustable for stock thicknesses from 0-1''Fits all existing Grr-Ripper push blocksEasy to use with two push blocks and the leapfrog method; heels grab the tail end of your board and automatically retract mid-boardIncreases control and stability when feeding long or short stock-provides extra support to help feed stock and prevent blow out
Fein's Large Vacuum Brush takes its inspiration from classic woodshop brushes used for clearing the benchtop of dust and shavings. Its natural bristles help dislodge the dust without scratching delicate surfaces. Use it for your benchtop, router table, shelves and for preparing pieces for finishing. Use with Fein Turbo I and Turbo II vacuums (52876 and 58694, sold separately)