ProLift Adapter 40-002 for select Porter-Cable, Bosch and DeWalt routers

Necessary accessory to mount the following routers in the Bench Dog ProLift router lift (28827, sold separately):Porter-Cable 690 SeriesPorter-Cable 890 SeriesBosch 1617Bosch 1618DeWalt 610DeWalt 616DeWalt 618

$32.99
Buy
 

Related Products

Rockler Router Plate Insert With 2-1/2" Opening For Large Plates

Rockler Router Plate Insert With 2-1/2" Opening For Large Plates
$8.99

The interchangeable insert for standard bits features a 2-1/2'' opening. The 4-3/8'' OD allows this insert to fit into a large plate with a 3-11/16'' opening. Fits the Following Router Lifts: Rockler Router Lift FX (23194) Bench Dog 40-150 ProLift Router Adjustment System (28827) Fits The Following Rockler Router Table Plates:Rockler Router Plate CPorter Cable 7518Porter Cable 7519Porter Cable 7538Porter Cable 7539Milwaukee 5625-20Triton TRA001Triton MOF001Rockler Router Plate DBosch 1619-1619EVFreud FT2000DeWalt 625

Rockler Router Plate Insert With 1-1/2" Opening For Standard Plates

Rockler Router Plate Insert With 1-1/2" Opening For Standard Plates
$8.99

The interchangeable insert for standard plates features a 1/2'' opening. The 4'' OD allows this insert to fit into a standard plate with a 3-1/4'' opening. Fits The Following Rockler Router Table Plates:Rockler Router Plate AMakita 1100Milwaukee 5615-5624DeWalt 616-618Bosch 1617- 161Rigid 2930 Combo KitHitachi M12VC (Fixed & Kit)Bosch MRC23EVSKPorter Cable 690Porter Cable 890Porter Cable 7529Porter Cable 97529Porter Cable 8529Rockler Router Plate BDeWalt DW621DeWalt DW621KCraftsman StandardFreud FT 1700EFreud 1702 VCEK

Rockler Small Trim for 1" Thick Doors Router Bit - 3/4" Dia x 1" H x 1/2" Shank

Rockler Small Trim for 1" Thick Doors Router Bit - 3/4" Dia x 1" H x 1/2" Shank
$49.99

If you need to trim a precise amount of wood off of doors and large panels, this kit will save you a lot of tedious setups and backaches. The kit uses a razor-sharp shear-cutting bit along with different bearing combinations to remove exactly 1/16", 1/8", or 3/16" of material in just two router passes-all without a straightedge! No need to strain your back lifting and balancing a large panel on top of a jointer. Instead, you bring the tool to the material. The kit includes one carbide router bit and five bearings to set up the various depths of cut. The bit can also be used as a double-bearing flush trim bit, as two bearings are included for that purpose. Capable of trimming stock up to 1" thick. Click the "Videos" tab to see how this kit will save you time!A larger version of the same kit is available separately (26841) for trimming stock up to 2" thick.Small Bit Kit includes the following:One 3/4" diameter bit with 1" long cutter and a 1/2" shankTwo 3/4" bearings for flush trimmingThree single bearings (5/8", 1/2", and 3/8" in diameter) for trimming 1/16", 1/8", and 3/16"