Rockler Drawer Pull Router Bit - 1-3/8" Dia x 7/8" H x 1/2" Shank

Use this bit to apply a comfortable finger recess around the edges of doors and drawers, useful when you want a clean look without knobs or other hardware. You can also use it to rout finger pull stock that is applied separately, and you can even use it as a decorative edge treatment for table tops and other cabinet components.

$49.99
Buy
 

Related Products

1/4'' to 4 mm Collet Reducer for Click-N-Carve Bits

1/4'' to 4 mm Collet Reducer for Click-N-Carve Bits
$6.99

This unique collet reducer lets you to use the wide array of proprietary Click-N-Carve CNC Router Bits with the larger CNC Shark line of routers, as well as any other CNC router or handheld router with a 1/4" collet. It reduces the collet opening from 1/4" to 4mm to accept the smaller Click-N-Carve shank. The Click-N-Carve selection offers many unique router bits, including Ball Nose Bits, End Mill Bits, Conical Ball Bits, and Half-Conical Bits for CNC Carving Machines.Technical Details:Collet reduces your standard 1/4" collet to a 4mm collet, which accepts the unique Click-N-Carve router bit shanks.Compression slots in collet reducer allow for tight fit when the collet is tightened.

Rockler Flush Trim V-Groove Router Bit - 1/2" Dia x 1" H x 1/2" Shank

Rockler Flush Trim V-Groove Router Bit - 1/2" Dia x 1" H x 1/2" Shank
$22.99

Sometimes it's better to emphasize a seam than to try to hide it. This bit does just that, applying a neat decorative V-groove along the line of the seam. Since you no longer have to sand the joint perfectly flush as you would with a typical flush trim bit, you also cut down on a lot of sanding. Just a pass or two with a palm sander is enough to remove any mill marks. Ideal for trimming cabinet face frames flush with the cabinet sides.

Freud Quadra-Cut Bevel Raised Panel Router Bits - 1/2" Shank

Freud Quadra-Cut Bevel Raised Panel Router Bits - 1/2" Shank
$98.97

This straight panel raiser cuts a classic design most famously employed in Shaker furniture. It is primarily designed to raise Shaker panels, but can also be used to bevel the underside of table tops. It features Freud's exclusive Quadra-Cut 4-cutter design, which provides the smoothest cuts possible. You'll get crisp, clean edges every time, even with cross-grain cuts in difficult materials.Application: Ideal for creating raised panels for doors and paneling, as well as for beveling decorative tops, plaques and moldingRevolutionary Quadra-Cutdesign combines two small wings that cut downward to shear the top edge for a splinter-free surface, and two large wings that shear upward for a smooth finish.Use 1/2" height for 5/8" stock. Use 5/8" height for 3/4" stock.Cuts all composition materials, plywoods, hardwoods, and softwoods.Use on table-mounted portable routers only.