You'll keep tools and accessories right where you need them with this 5" x 18" x 3" Dust-Free Shop Tray! This rugged galvanized steel tray has a mesh bottom designed to hold your router tools, bits, wrenches, pencils, tape measure, and other shop accessories ... anything except dust and debris which falls through the mesh bottom. Includes two sets of pre-drilled mounting holes, one set is 16"-on-center (3/8" diameter hang slot), the other (3/16" H x 3/8" W oval) set fits any of our 18" deep Steel Shop Stands, including our Router Table Steel Stand. Made in USA.Technical Details: Ruggedly built out of galvanized steel Holds router bits, wrenches, tape measure, pencil, and more Mesh bottom allows dust and debris to fall to the floor for efficient cleanup Includes two sets of pre-drilled mounting holes, one set is 16"-on-center (3/8" diameter hang slot), the other (3/16" H x 3/8" W oval) set fits any of our 18" deep Steel Shop Stands, including our Router Table Steel Stand. Measures 5" x 18" x 3" high Made in USA
Finally, an affordable dust collection attachment for your Rockler dovetail jig! You don't have to spend hundreds of dollars to get dust collection with a dovetail jig. Our revolutionary new dust collector eliminates virtually all the dust created when cutting dovetails. It easily attaches to Rockler's dovetail jigs (both new and old!) and a shop vacuum or dust collection system to provide you with a clean cutting area and safe working conditions.Easily attaches to Rockler's dovetail jigs Built-in 2-1/4" port fits most shop vac hoses (not included).Sliding baffle directs the dust collection to where the dovetails are being cut.Sweep brush adjusts to provide a complete seal for stock thicknesses of 1/2" up to 1-1/8".Contains the dust while allowing the bit to travel through without damage.Two extra long 4" knob posts make adding your dust collector shroud easy.Built-in 2-1/4" port fits most shop vac hoses (not included).For older Rockler dovetail jigs with 4-screw side stops, conversion kit #25174 is required. (Sold out and no longer available).Patent pending.
For use with the Rockler Shutter System. Use this router bit to add elegance and style to your custom shutters. Use with the included bearing to put a bead on your shutter stiles, then remove the bearing to cut a chamfer on your shutter rails. 1/2" shank.Ready to build your own custom shutters with ease? View all of our Shutter Jig Templates and select the style that is perfect for your application!
With its graceful, elongated round over accented by a small bead, the profile on this edge forming bit looks at home on a wide variety of cabinetry styles. The 3/8" guide bearing makes setups fool-proof, and the 1/2" shank with high-grade carbide leaves a smooth, chatter-free cut.