Our beading bits come in a range of sizes to suit many applications. Use the smaller bits to make beaded trim moldings, and the larger bits for bull-nosed edges on thicker stock. A 1/4" beaded molding mitered around doors and drawer fronts adds a subtle and strikingly attractive effect. In bullnosing applications, a beading bit gives you a true half-round profile, without the flat in the middle that a round over bit would leave. It also machines the edge in one pass rather than two. All of these bits feature sturdy 1/2" shanks for extremely smooth, stable routing.
Provided your router has enough horsepower, horizontal panel raising bits offer an exceptionally smooth shearing cut, and virtually eliminate fuzzing on the end grain of your panels. In addition, they allow you to raise panels with curving profiles, such as for arched doors or cathedral style doors. These raised panel bits are manufactured to Rockler's exacting standards, and include guide bearings to ensure proper relief to fit into the grooves of your rail and stile doors.
Replacement Plunge Base for Models 693LRPK and 694VK. Compatible with Router Motors 6902 & 6902VS. Fits most 3-1/2" diameter Porter-Cable (or previous Rockwell), motors.Technical DetailsFits most 3-1/2" diameter Porter-Cable (or previous Rockwell), motors 350, 630, 670, 690, 691. Not recommended for use with models 100, 100M 150 M, 1002 and 1502Provides all the plunging capabilities and operation benefits described with Model 693Model 6931 Base also fits the following competitive routers: Black & Decker Model 2720. Bosch Models 1601, 1602, 1603, 1604, 1606.
This advanced model of the GRR-Ripper boasts all of the same innovative features of the GR-100 but comes with two additional accessories (see below) that improve the control and expandability of the GRR-Ripper System. The Micro Jig GRR-Ripper Advanced 3D Pushblock (GR-200) is designed to feed your workpiece more safely and more accurately than with conventional push blocks, resulting in intact fingers, less burning and less waste. With its 3-Directional control, it gives you downward, forward, and lateral pressure on the stock for maximum control. Since it acts as a movable blade guard that travels with your hand, it provides an additional safety buffer between the blade and your hands. Whether you are making razor-thin veneer strips, building miniatures, or creating exquisite furniture you will save time, materials, and fingers with the GRR-Ripper.The GR-200 includes these additional accessories:The Adjustable Spacer - This accessory adds increased gripping surface for tackling larger stock. It also adds one inch of cutting width to the GRR-Ripper and acts as a secondary balance support for small stock and straight-line ripping. Great add-on for working on the router table, and eliminating snipe.The Stabilizing Plate - The Stabilizing Plate adds a new dimension of control to the GRR-Ripper. It is particularly useful when cutting small narrow pieces of stock. Perfect for trickier cuts like resawing, bevel edging, pattern routing, and much more.The Stabilizing Plate also acts as a secondary fence that travels with the GRR-Ripper along the left side of the stock. It holds the off-cut piece in its original position through the entire cutting operation. Some users call it a "Feather Board Plate," but unlike a featherboard, it exerts no sideways pressure. Instead it simply holds the drop-off piece in position as it travels past the blade, preventing binding.Watch a video demo today by clicking on the "Videos" tab above.