These collet extenders allow you to change router bits from above the table-even without a lift! Even if you have a lift, they still make bit changes easier because you won't have to remove the insert ring. They're also great for custom made router tables with very thick tops, as they provide the additional depth of cut needed for many routing tasks. Use them with our Router Table Spline Jig (59288, sold separately) to achieve full depth of cut when machining dovetail splines.
Freud's exclusive Quadra-Cut Beading Bits cut a precise radius with a step on either side, the perfect combination of tactile softness and visual definition. The 4 cutter Quadra-Cut design provides the smoothest cuts possible. You'll get crisp, clean edges every time, even with cross-grain cuts in difficult materials.Beading bit applications: Create decorative bead edges.Cuts all composition materials, plywoods, hardwoods, and softwoods.Use on hand-held and table-mounted portable routers.Note: 53971-should be used with a minimum 2-1/2HP router (3HP and up is better) at a max of 12,000 RPMs.
This unique collet reducer lets you to use the wide array of proprietary Click-N-Carve CNC Router Bits with the larger CNC Shark line of routers, as well as any other CNC router or handheld router with a 1/4" collet. It reduces the collet opening from 1/4" to 4mm to accept the smaller Click-N-Carve shank. The Click-N-Carve selection offers many unique router bits, including Ball Nose Bits, End Mill Bits, Conical Ball Bits, and Half-Conical Bits for CNC Carving Machines.Technical Details:Collet reduces your standard 1/4" collet to a 4mm collet, which accepts the unique Click-N-Carve router bit shanks.Compression slots in collet reducer allow for tight fit when the collet is tightened.
Tune up your table saw to the peak of perfection.Tune up your table saw to the peak of perfection.Get the highest degree of accuracy with this combination Master Plate and Super Bar. Together, they help you tune-up, calibrate, and align your table saw to within 1/1000 of an inch! What's more, it promotes safer operation by helping to eliminate kickbacks, sticking, and binding. The master plate is made of solid 1/4" thick, flat-ground aluminum. It replaces your saw blade and bolts into a 5/8" or 1" arbor to provide a full 10" of near-perfect flatness for aligning your equipment. The Super Bar jig has an-onboard precision dial indicator that measures alignment as it slides in the miter gauge slot. This enables you to keep the saw blade parallel, align the fence, square tour protractor, and check runout on routers, drill presses, and more!