EZSmart B300 Bridge Kit

With the EZSmart B300 Bridge Kit, loading and offloading materials for cutting with your track saw system is easier than ever. Simply slide your material under your guide rail (sold separately), then pull the lever to lower the rail onto your material. When the cut is finished, push the lever to raise the guide rail so you can remove the piece. There is no need to remove your saw, and no need to move an unwieldy guide rail around or stand it against the wall as you load a new piece. The bridge also applies pressure so no clamps are needed to secure your work. The B300 Bridge Kit can be used on a DIY workbench or with the EZSmart Multiform Master Table (50791, sold separately). Made in USA. Use to mount your EZSmart, Festool, Makita, or DeWalt guide rail to any workbenchEasily raise or lower the guide rail with one easy motionOnce lowered, the guide rail holds the material securely in place for fast, safe cuttingBridge has the capacity to cut anything from the thinnest plywood to timbers up to 5'' thickHeavy duty construction for smooth operation and long life

$229.99
Buy
 

Related Products

Freud 10'' Thin Kerf Sawblades - 24T General Purpose and 80T Crosscut (Pack of 2)

Freud 10'' Thin Kerf Sawblades - 24T General Purpose and 80T Crosscut (Pack of 2)
$119.99

This twin pack of Freud blades includes a 24T General Purpose Blade for ripping and dimensioning, and an 80T Ultra-Fine Crosscut Blade for the fine finishing cuts on intricate molding and joinery. Both blades feature thin-kerf technology, which is less taxing on your saw, and generates less waste. Laser-cut bodies with expansion slots remain flat and stay sharp longer. Micro-grain carbide tips with tri-metal brazing can be re-sharpened up to six times. Covered by Freud's Limited Lifetime Warranty.

Fein Flush Cut Saw Blade 3-11/32''

Fein Flush Cut Saw Blade 3-11/32''
$169.99

For use with the Fein MultiMaster, the Flush Cut Blade has a depressed center so you can cut squarely against flat surfaces. Use for plastics, fiberglass, wood, putty, non-ferrous metal and sheet metal, flush to the surface.

Freud LU91R Thin Kerf Sliding Compound Miter Saw Blades

Freud LU91R Thin Kerf Sliding Compound Miter Saw Blades
$63.97

This thin kerf industrial blade provides a superior finish cut with sliding compound miter saws. The 5° negative hook angle helps prevent the blade from being too aggressive and pushes the work piece down and towards the fence. Thin kerf blades remove less material than standard carbide blades, thus requiring less horsepower to produce equally good results.The Perma-SHIELD coating covers the blade plate and cutting edge in a protective layer, reducing heat build-up. Perma-SHIELD blades resist binding in large volume cutting, reducing subsequent blade warp. The coating lubricates the blade, allowing it to spin freely, and eliminates pitch and debris build-up on the blade.Also available with the economical Silver I.C.E coating.