High Speed Steel Saw Blades for the Fein MultiMaster in 2-1/2" diameter. The HSS Saw Blades are suitable for plastics, fiberglass, non-ferrous materials, and sheet metal up to 1 mm. Available as a single blade, or in packs of 2 or 5.
Compact size makes this the most affordable Incra miter gauge ever!Engineered to provide high performance for your table saw, band saw, router table, disk sander, belt sander or any other tool in need of a better miter gauge.Technical Details:Features exclusive AngleLock indexing systemAdjustable GlideLock miter bar with four expansion points adjust for zero side playTwenty-seven laser cut pre-sets for perfect angles in 5° increments over a full 120° range.With 27 positive angle stops in 5° increments (+/- 60° range) and special stops at +/- 22-1/2°. For use in any standard 3/4" x 3/8" miter slotUniversal mounting bracket will support any user-made fence as well as any Incra fence.Includes removeable T-clip for use with T-shaped miter slots
This cam-action stop for the Best Fence lets you place the stop anywhere you want with precision and ease. A magnifying glass is built in so reading the tape measurements is easy. Stops can be lifted up and out of the way when not needed, and flipped back down without losing your measurement.Calibrating the stop is simple with the included sacrificial fence. Just set the pointer to zero on the fence scale, making sure the end of the sacrificial fence is past the miter saw blade, and make a cut. To recalibrate, extend the sacrificial fence further and recut. The sacrificial fence is a standard 1x3 size, so it's easy to replace if necessary.Stops can be reset to the opposite side of the saw; both the sacrificial fence and fence pointers are reversible.See the Best Fence v3 System here.Technical Details:Cam-action stop locks solidly into place and flips out of the way when not in useA large, comfortable handle makes it easy to lock and unlock the stopSacrificial fence allows for easy calibration to any miter sawRemovable pointers and sacrificial fence allow the stop to be recalibrated for the opposite side of the sawA swing-out magnifying glass clearly shows the tape measurements
Easily build shelving and other furniture projects with standard 1" x 4" materials and I-Semble Slip-on Shelf Brackets! All you need is a saw to cut stock to length and a drill to drive screws. Ideal for holding books, flat-screen TV, stereo, and more in a bedroom, dorm room, living room, or rec room. These durable ABS brackets slide over a standard 1" x 4" (3/4" x 3-1/2") to create vertical sides of a shelving unit. Position and mount the brackets at the desired shelf height, then add shelves to length and secure them to the brackets using the included mounting hardware. All you need is a drill and a hand or power saw and you're ready to build! Sold in sets of four. Also available: 1"x10" Slip-On Shelf Brackets.Building backless shelving systems and furniture with our I-Semble Slip-on Shelf Brackets couldn't be much simpler, but if the shelving system is very large, you might need some additional support against racking. That's where the I-Semble Cross Strap Bookshelf Stabilizer Kit comes in. Without clunky braces or supports, the two wires in the system "tie off" the diagonals of your bookshelf to prevent racking.Technical Details:Accepts nominal 1x4s (3/4" x 3-1/2").Built from sturdy ABS plastic (not for use as a ladder).Includes assembly screws.Simple construction requires only a drill and a saw to cut your pieces to length.