Kreg Rip-Cut Circular Saw Guide

There's no need to juggle guide rails, a pencil or tape measure. In fact, there's no measuring or marking required - just slide the fence on the Rip-Cut to any setting from 1/8" to 24" and rip a clean, straight line right down the length of the sheet. The Rip-Cut attaches easily to virtually any circular saw, whether left- or right-handed. Adjusting the fence is easy, simply open the cam lever, and slide it to your setting, just like a table saw fence.Quickly and easily connects to most hand-held circular saws.Reversible guide arm allows you to use it either right- or left-handed.Includes easy-to-read adjustable scale that can be zeroed to your blade.Fence moves with the saw, providing support through the entire length of the cut. Rips 4' x 8' plywood in two.

$34.99
Buy
 

Related Products

SawStop Standard Brake Cartridge

SawStop Standard Brake Cartridge
$69.00

SawStop is revolutionizing table saw safety. The Standard Brake Cartridge is for 10" saw blades and fits all models of SawStop table saws (except older models). Current models use brake cartridges with a blue tinted plastic case and 9-pin connector. Designed for quick replacement when activated and compatible with all woods and other non-conductive materials.

Incra Miter Gauge V27

Incra Miter Gauge V27
$67.99

Compact size makes this the most affordable Incra miter gauge ever!Engineered to provide high performance for your table saw, band saw, router table, disk sander, belt sander or any other tool in need of a better miter gauge.Technical Details:Features exclusive AngleLock indexing systemAdjustable GlideLock miter bar with four expansion points adjust for zero side playTwenty-seven laser cut pre-sets for perfect angles in 5° increments over a full 120° range.With 27 positive angle stops in 5° increments (+/- 60° range) and special stops at +/- 22-1/2°. For use in any standard 3/4" x 3/8" miter slotUniversal mounting bracket will support any user-made fence as well as any Incra fence.Includes removeable T-clip for use with T-shaped miter slots

Candle Holders Downloadable Plan

Candle Holders Downloadable Plan
$1.00

A saw kerf cut down the center of these unique candle holders creates a spring-clamp action that secures the candle. Ours are made from oak, although any straight-grained hardwood can be used. This plan yields a pair of candle holders.