Rockler Dovetail Miter Bars

Some of the pickiest machining operations require a jig that won't lift or tip in the slightest, and that's where the new Rockler Dovetail Miter Bar excels. With its 14° wedge-shaped profile, it holds your jig firmly to the work surface for precision, consistency and repeatability where lifting is a concern. Whether you're cutting box joints, finger joints or thickness planing with a router, adding a Dovetail Miter Bar to your jig will increase accuracy and reduce production time. The uses of this one are limited only by your imagination. Sold in 18" or 24" lengths, the Dovetail Miter Bars can easily be cut shorter if needed.Features:Rockler Dovetail Miter Bars are designed to match the profile of our 5/8" Diameter, 14 degree Dovetail Router Bit (91089, sold separately), but it will also match virtually any 5/8" 14° dovetail bit.1/8" tab along the bottom edge of the Dovetail Miter Bar fits into a saw kerf to prevent slippage, and to increase the strength.Screws not included, since screw length would vary too much for different applications.For 3/4" material, we recommend using #6 1" screws.Dovetail keys are made of aluminumFor the lowest possible friction while sliding the jig, use with nylon tape (e.g. 70615).When using nylon tape on your jigs, be sure to make allowances for the thickness of the tape when you rout the dovetail channel.

$5.99
Buy
 

Related Products

Fein Flush Cut Saw Blade 3-11/32''

Fein Flush Cut Saw Blade 3-11/32''
$169.99

For use with the Fein MultiMaster, the Flush Cut Blade has a depressed center so you can cut squarely against flat surfaces. Use for plastics, fiberglass, wood, putty, non-ferrous metal and sheet metal, flush to the surface.

Freud 10'' Thin Kerf Sawblades - 24T General Purpose and 80T Crosscut (Pack of 2)

Freud 10'' Thin Kerf Sawblades - 24T General Purpose and 80T Crosscut (Pack of 2)
$119.99

This twin pack of Freud blades includes a 24T General Purpose Blade for ripping and dimensioning, and an 80T Ultra-Fine Crosscut Blade for the fine finishing cuts on intricate molding and joinery. Both blades feature thin-kerf technology, which is less taxing on your saw, and generates less waste. Laser-cut bodies with expansion slots remain flat and stay sharp longer. Micro-grain carbide tips with tri-metal brazing can be re-sharpened up to six times. Covered by Freud's Limited Lifetime Warranty.

Freud LU91R Thin Kerf Sliding Compound Miter Saw Blades

Freud LU91R Thin Kerf Sliding Compound Miter Saw Blades
$63.97

This thin kerf industrial blade provides a superior finish cut with sliding compound miter saws. The 5° negative hook angle helps prevent the blade from being too aggressive and pushes the work piece down and towards the fence. Thin kerf blades remove less material than standard carbide blades, thus requiring less horsepower to produce equally good results.The Perma-SHIELD coating covers the blade plate and cutting edge in a protective layer, reducing heat build-up. Perma-SHIELD blades resist binding in large volume cutting, reducing subsequent blade warp. The coating lubricates the blade, allowing it to spin freely, and eliminates pitch and debris build-up on the blade.Also available with the economical Silver I.C.E coating.