This solid carbide cutter was sharpened on a diamond wheel to 1500 grit, and can be rotated to give you a fresh edge in only seconds! Use it with the Round Carbide Mini Turning Tool or the Round Carbide Pen Turning Tool (both sold separately) to get smooth finishes on concave surfaces!Technical Details:Ideal for giving you a smooth finish on curved, concave surfaces and for general turning applications.Cutter rotates, giving you numerous fresh edges with no need for sharpening.Sharpened on a diamond wheel to 1500 grit.Solid carbide stays sharper for longer, when compared with steel.
Outside Banjo Support Bracket for Laguna REVO 10 x 16 Mini Lathe.The Banjo Support Bracket is an accessory attachment for the Laguna REVO 10 x 16 Mini Lathe . The bracket bolts onto your lathe to move the tool rest further away from the tail stock, increasing the bowl turning capacity of the REVO from 10" to 16" in diameter.Technical Details:Solid cast iron construction.Easy bolt-on installation.Increases bowl turning capacity from 10" to 16" in diameter.
A complete set of bushings for Rifle Cartridge Bullet Pen Hardware Kits (Chrome, and Gold sold separately). These pen bushings are precisely machined to match the diameters of your pen blanks, allowing you to achieve the smooth, perfectly flush seams so valued in a top quality hand-turned pen. Simply turn your pen blanks to match the bushing diameters, leaving a bit of extra material to allow for sanding.Technical Details:The Rifle Cartridge Bullet Pen Bushing Set is made of steel-hard enough for excellent durability, yet soft enough to prevent damage to your turning tools.2-piece bushing set.Bushings are designed to work with Rifle Cartridge Bullet Pen Hardware Kits of bushings for Rifle Cartridge Bullet Pen Hardware Kits (Chrome, and Gold sold separately). Tip: when turning light-colored woods, apply a bit of CA glue to the bushings to prevent metal dust from migrating onto the turning blank.
Micro-Mesh is used to polish surfaces back to clarity or a high gloss. Available in grades 1500-12,000.Micro-Mesh (Grades 1500 through 12000) was originally designed to polish most hard plastics, fiberglass, epoxy, gel-coat, raw and finished wood, cultured marble, sold surface, painted surfaces, gold, silver, etc. Micro-Mesh is not an aggressive stock remover. Common sandpaper products are required for the removal of deep scratches prior to using Micro-Mesh to polish the surface back to clarity or a high gloss. Use wet or dry with either water or water/detergent as a lubricant. You may also use mineral oil, vegetable oil, lemon oil, etc but DO NOT use anything containing solvent as this will delaminate the MICRO-MESH. Sheets are offered in the following Micro-Mesh grades: 1500, 1800, 2400, 3200, 3600, 4000, 6000, 8000, 12000