KC Wire Burners

Add crisp detail to your turnings! These unique tools etch out precise decorative lines in all types of wood. Three sets available. Use the 6" Set for pens and other small turnings, the 9" Set for long spindles, and the 18" Set for bowls and other faceplate work. Each package includes three burners with wires of varying thickness.Every KC Wire Burner features a unique ball-and-wire design that provides remarkable two-handed control. Each burner is made with two finely-sanded wooden balls and high-quality instrument wire.6" Set:Use on pens and other small turningsGreat for defining beads or adding simple decorative accentsWire diameters measure .016", .020", and .026".9" Set: Use on table legs and other spindle turningsGreat for defining beads or adding simple decorative accentsWire diameters measure .016", .026", and .039"18" Set: Use on bowls, plates, and other larger faceplate work.Great for defining beads or adding simple decorative accentsWire diameters measure .020", .033", and .045"

$11.59
Buy
 

Related Products

Collets for Robert Sorby Sovereign Handles

Collets for Robert Sorby Sovereign Handles
$12.99

These collets are for use with the Robert Sorby Sovereign Turning Handles (e.g. 44540, sold separately). The collets reduce the size of the opening on the Sovereign Handle, allowing it to be used with a wide variety of turning shanks. They are made of machined aluminum, and are available in 3/8" and 1/2" sizes, as well as a tang model.Technical Details:Collets are made from machined aluminum to precise tolerances.Use the 1/2" collet (47155, sold separately) for the TurnMaster shanks (e.g. 45649, sold separately).Note: American-made tools are measured by bar diameter while European brands are measured by flute size. So the 3/8" collet is designed for a European 1/4" gouge, the 1/2" collet for a European 3/8" gouge, and a European 1/2" gouge will fit directly into the Sovereign handle.

Robert Sorby Parting Tools

Robert Sorby Parting Tools
$54.49

Standard Parting Tool - Used to part the finished project off from the waste material, the parallel sides make for a rigid tool that handles well. The 1/8" -3mm tool reduces the amount of waste, vital if the timber is an expensive, exotic one. It also makes for a fine detailing tool, e.g. beads and fillets.Diamond Parting Tool - The special profile of this tool reduces the risk of binding in the cut. It also reduces the amount of heat build up caused by friction, thereby lessening the chance of burning the bottom of the parted project.

Full Size Round Carbide Replacement Cutter - R2

Full Size Round Carbide Replacement Cutter - R2
$19.99

This solid carbide cutter was sharpened on a diamond wheel to 1500 grit, and can be rotated to give you a fresh edge in only seconds! Use it with the Full Size Round Carbide Turning Tool (48723, sold separately) to get smooth finishes on curved, concave surfaces.Features:R2 replacement cutter measures approximately 0.60'' in diameter.Ideal for giving you a smooth finish on curved, concave surfaces and for general turning applications.Cutter rotates, giving you numerous fresh edges with no need for sharpening.Sharpened on a diamond wheel to 1500 grit.Solid carbide stays sharper for longer, when compared with steel.