T-style knobs are the perfect choice for that jig or fixture that requires a little extra torque, or when you need a nice easy target to flick when spinning the knobs on and off. These T-knobs from Rockler have a pleasant textured surface and a threaded insert made of brass. The hole runs all the way through the knob, so there's no risk of the T-bolt bottoming out on the plastic. Choose from two different thread patterns.Technical Details: 2" knob with textured surfaceThreaded insert made of brassChoose from two different thread patterns
Jig Includes Drill Bit, Stop Collar, and Stop Collar Wrench for Added Convenience!An incredibly affordable doweling jig for those who want a quick joint without the fussy layout.Rockler Doweling Jigs are transparent, you need only set the two parts together, strike a line across the face of the joint and line up the jig.Made to last with a 3/16" acrylic faces and hardened steel drill guides.1/4" guide has holes spaced 3/4"-on-center.Also Available from Rockler:Rockler 3/8" Dowel Drilling JigRockler 1/2" Dowel Drilling JigTechnical Details:Delivers a quick joint setup in just a moment of timeNo need to transfer marks from the face to the edge, or measure and mark with a tape measureSimply set your two parts together, strike a line across the face of the joint and line up the jigMade to last with a 3/16" acrylic face and hardened steel drill guides1/4" guide has holes spaced 3/4"-on-centerJig is designed to center dowel holes on 1/2" thick stock.Drill BitStop Collar and Stop Collar Wrench
With Universal T-Tracks on every face, these 36" tracks are full of potential - use them to create custom fences, jigs and fixtures. Once assembled, the multiple tracks give you countless options for attaching stops, hold-downs, sub-fences and more. Available in 2-1/4" and 3" heights. Multi Track Brackets and Flip Stops sold separately.Technical Details:Universal T-tracks accept all three major accessory fasteners: 1/4" T-bolts, 1/4" Hex Bolts and 5/16" T-boltsSolid extruded aluminum construction for strength and durability3/4" ThickT-tracks are spaced 3/4" apart (on center) for simple assembly and optimal utility
Using CA glue to finish your pen turnings results in a lustrous, glossy polish,but it can also fuse your pen blank to the bushings. Not so with these non-stick polyethylene bushings in place, however. These bushings are made fromUHMW, the same super-slippery polymer used in our Plastic Jig Stock. They'repre-drilled for a standard mandrel, and have a 60° taper so they'll fit most anysize pen bushing. Just swap these for your metal bushings once the pen isturned, and apply your finish. 4-Pack.Technical Details:Non-Stick Pen Bushings are made of UHMW (Ultra-High Molecular Weight)polyethylene.Pre-drilled for a standard 7mm mandrel (e.g. 43537, sold separately).60° cone-shaped taper fits any size pen bushing.After shaping the pen blank, replace the metal bushings with non-stick plasticbushings and apply your CA finish.Self-lubricating UHMW has a low coefficient of friction, so it sheds glue easily.Very stable - 10x heavier than regular high-density polyethylene.High abrasion resistance and high impact strength even at low temperatures.Resistant to chemicals.