Tightening Rockler's new Auto-Lock T-Track Hold Down Clamp is literally an open-and-shut case-just press down the lever to secure anything from veneer sheets to lumber up to 2-3/4'' thick! Once set, the clamping pressure is always the same regardless of workpiece size, and is adjusted only if needed with the set screw. The clamp pivots 360°, allowing you to clamp near the workpiece edge to minimize obstructions. A large knurled wheel locks the clamp securely to the T-track. The toggle foot is adjusted with the knurled aluminum knob for best placement-no wrenches required-while the clamping foot pivots on a ball joint so it can adapt to any angle and is rubber coated to prevent marring. Simply lift the lever to release. Auto-adjust mechanism allows you to clamp various thicknesses without readjustingCenter of clamping foot extends from 1-1/2'' to 3-1/2'' from center of trackMax height capacity is 2-3/4''Clamping force is adjustable from 5-250 lbs of pressureLarge locking wheel secures clamp to T-trackClamps slide into any T-track that accepts 5/16'' T-bolts, including our T-Track Table (46654, sold separately) and many of the CNC Shark tablesAn optional Mounting Bracket (57940) is available for securing the clamp to shop-made jigs and fixturesHeavy-duty metal construction
With the six jigs in this kit, you'll be able to shape and sharpen all your knives, scissors, shears, draw knives and axes, as well as short chisels and carving tools. Each jig perfectly replicates the edge angle so you can sharpen faster than ever. The jigs in this kit work with the T-7 and T-4 Tormek Sharpening Systems (35254 and 53332, sold separately) as well as the older T-3 system. The Knife Jig (SVM-45) works to sharpen most knives, including carver's draw knives. Long knives need to be stiff, and the minimum blade length is 2-3/8'' (60mm)The Long Knife Jig (SVM-140) is suitable for long and flexible knives. The jig's 5-1/2'' (140mm) width stabilizes a thin blade. Requires minimum blade length of 6-5/16'' (160mm)The Scissors Jig (SVX-150) is for scissors of all sizes as well as shears. It is also suitable for portable electric hand planer bladesThe Short Tool Jig (SVS-32) is for straight-shanked carving gouges and V-tools down to 1-3/4'' (45mm) long. It also sharpens short wood chisels and tools for power carvers. Maximum tool width is 1-1/4'' (32mm)The Axe Jig (SVA-170) sharpens carving and carpenter's axes. It accommodates a maximum axe height of 6-11/16'' (170mm), and copes with both straight and curved edgesThe Small Knife Holder (SVM-00) enables you to sharpen the smallest knife blades like carving knives and pocket knives. Works in conjunction with the SVM-45 Knife Jig
These collet extenders allow you to change router bits from above the table-even without a lift! Even if you have a lift, they still make bit changes easier because you won't have to remove the insert ring. They're also great for custom made router tables with very thick tops, as they provide the additional depth of cut needed for many routing tasks. Use them with our Router Table Spline Jig (59288, sold separately) to achieve full depth of cut when machining dovetail splines.