Economical and practical, this jig is ideal for adding shelves to assembled, unassembled, new, or existing cabinetry. Re-designed handle includes two storage compartments for self-centering bits! Additional Self-Centering Bit sizes available separately. Drills holes either 1-7/16" or 2-1/2" from edge. Insert shelf pin in top or bottom position to extend jig for continuous drilling.Shelving Jigs measure 20" longProvides exact set back for shelf pin holes of 37mm (1-7/16") or 64mm (2-1/2"). Included hex wrench is all you need to remove and tighten fixtures when repositioning handle for different applications.Clear template features laser cut accuracy. Designed for both face frame and frameless construction. Template system designed to work with 4 bit sizes: 1/4" and 5mm for shelf pins, 7/32" and 9/32" for pin sleeves. 32mm system compatible. 32mm spacing and 37mm or 64mm setback.Using the Multi-Position Drilling Template:Determine setback required for your project: 2-1/2'' (64mm) or 1-7/16'' (37mm).Mount the handle on the appropriate edge of jigChoose row depending on use: Face Frame or Frameless.Self-Centering Drill Bits:Self-centering bits are pre-set to bore a consistent depth for perfect fitting shelf pins and sleeves every time. No adjustments are necessary! Various bit sizes available separately for both shelf pins and shelf pin sleeves. Decorative metal shelf pin sleeves provided added shelf strength.#22567 - 1/4'' Bit for 1/4'' Shelf Pin#22575 - 5mm Bit for 5mm Shelf Pin#34368 - 9/32'' Bit for 1/4'' Shelf Pin Sleeve#34342 - 7/32'' Bit for 5mm Shelf Pin Sleeve
Every once in a blue moon you miss the tunnel of your Grr-Ripper push block and end up nicking the leg. Luckily, thanks to the push block, it's a lot cheaper to replace a plastic leg than a finger (and a lot less painful). All three Grr-Ripper replacement legs are available: the Center Leg, 1/4" Leg, and 1/2" Leg. All three are compatible with both the GR-100 and GR-200 Grr-Ripper models (sold separately, 62689 and 30737).Technical Details:Center Leg is adjustable laterally to hold stock flat against the table.Installation hardware not included. Please use hardware from your previous Grr-Ripper leg.Keep the green Grr-Ripper pads clean with denatured alcohol or rubbing alcohol.
This optional Dowelmax 1/8" spacer plate enables centering for Dowelmax Classic and Dowelmax Jr. doweling jigs on 1" thick work pieces. It also allows for different offset options when used in combination with other Dowelmax spacers.Technical Details:Components are made of top quality aluminumPrecision-machined to a tolerance of 0.002"Requires Dowelmax Classic or Dowelmax Jr. doweling jig
Get three-way adjustability in face frame applications! 120° swing opening. See optional Blumotion Soft Close System for silent and cushioned door closure. This hinge is compatible with the JIG IT Hinge Plate Template D #57345 (Sold Separately) for faster, more precise installation.