Each Micro Jig ZeroPlay Guide Bar is composed of two interlocking plastic bars that adjust laterally to theexact width of your miter slot to stabilize your jigs. Guide bars are easily calibrated from the top of jigs and fixtures and are easy to retrofit. The ZeroPlay Guide Bar is a "One-Touch Calibration" miter bar (9-1/2" in length) that has two stacked half bars with opposing wedges that expand parallel evenly to fit the exact width of a standard miter slot for a perfect fit and smooth glide, even fits tricky Shopsmith or General's miter slots.
Bessey K-Body Revo Parallel Clamps: For high pressure clamping (nominal force of 1500 lbs.), 90 degree clamping, or powerful spreading, the new K-Body REVO is an ideal choice. Its large, parallel jaws are uniquely designed to distribute even pressure across the entire surface of your work to stop bowing, turning, and lifting. The K-Body's updated design includes three removable jaw protection caps to help prevent wear. They are repellent to glue, easily replaceable, and resist paint and grease solvents. A quick-release feature allows the movable jaw to slide up and down the rail by simply angling the comfortable Power-Grip handle. Plus, each clamp includes two slip-on workpiece supports that attach to the rail, providing a stable base and preventing direct contact between the clamp and the actual workpiece. Compatible with K-P clamp blocks and the K-Body Clamp Extender.Bessey K-P Clamp Blocks: This rail and stile clamping kit from Bessie provides perfect squareness when clamping doors, frames, and more. K-P Blocks allow you to cross your clamps without interference while maintaining vertical clamp bodies.They are excellent for raised panel doors, entrance doors, cabinets, window frames, picture frames and boxes. The blocks are compatible with all K-Body clamps from 12'' to 98'', and can mount directly to your work surface as a permanent jig.
Finally, an affordable dust collection attachment for your Rockler dovetail jig! You don't have to spend hundreds of dollars to get dust collection with a dovetail jig. Our revolutionary new dust collector eliminates virtually all the dust created when cutting dovetails. It easily attaches to Rockler's dovetail jigs (both new and old!) and a shop vacuum or dust collection system to provide you with a clean cutting area and safe working conditions.Easily attaches to Rockler's dovetail jigs Built-in 2-1/4" port fits most shop vac hoses (not included).Sliding baffle directs the dust collection to where the dovetails are being cut.Sweep brush adjusts to provide a complete seal for stock thicknesses of 1/2" up to 1-1/8".Contains the dust while allowing the bit to travel through without damage.Two extra long 4" knob posts make adding your dust collector shroud easy.Built-in 2-1/4" port fits most shop vac hoses (not included).For older Rockler dovetail jigs with 4-screw side stops, conversion kit #25174 is required. (Sold out and no longer available).Patent pending.
FastCap's SpeedTape provides a clean, efficient way of applying veneer, edging and even small moldings with no messy overspray or expensive hot-melt edging machines. Just peel off the liner on one side, apply to the edge, peel off the other liner, and roll on your edging. The adhesive increases in strength as it cures, providing a long-lasting permanent bond.Technical Details:FastCap SpeedTape is completely waterproof. Rated from 30° to 250°. SpeedTape is made with high-performance acrylic "Ultra Bond" double-sided PSA adhesive. As always, do a test to ensure SpeedTape is suitable for your application.Finishing veneers is very important with SpeedTape - always follow finishing instructions precisely. Ideal for: edgebanding, veneers, laminate, applying carpet, jigs and fixtures, general adhesives, peel-and-stick moldings.