Spend a day or two making this classic workshop project and the results will improve your woodworking accuracy for years to come. The sled makes it easier to perform crosscuts on long or heavy stock and panel material. Our design also includes a mitering fence for dead-on angle cuts and a micro-adjustable stop block.
Once attached to a bench or fixture, this clamp works great as a quick-action hold down for jigs or as a simple way to secure a work piece. Its holding capacity is approximately 200 pounds.Bottom of rubber foot adjusts from 1/4" above mounting surface to 3/8" below mounting surface. Total length with arm extended and T-handle up is 2-5/8". Height is 2-1/4".Mounting plate is 1-9/16" W x 1" L.Does not include mounting screws.
Tightening Rockler's new Auto-Lock T-Track Hold Down Clamp is literally an open-and-shut case-just press down the lever to secure anything from veneer sheets to lumber up to 2-3/4'' thick! Once set, the clamping pressure is always the same regardless of workpiece size, and is adjusted only if needed with the set screw. The clamp pivots 360°, allowing you to clamp near the workpiece edge to minimize obstructions. A large knurled wheel locks the clamp securely to the T-track. The toggle foot is adjusted with the knurled aluminum knob for best placement-no wrenches required-while the clamping foot pivots on a ball joint so it can adapt to any angle and is rubber coated to prevent marring. Simply lift the lever to release. Auto-adjust mechanism allows you to clamp various thicknesses without readjustingCenter of clamping foot extends from 1-1/2'' to 3-1/2'' from center of trackMax height capacity is 2-3/4''Clamping force is adjustable from 5-250 lbs of pressureLarge locking wheel secures clamp to T-trackClamps slide into any T-track that accepts 5/16'' T-bolts, including our T-Track Table (46654, sold separately) and many of the CNC Shark tablesAn optional Mounting Bracket (57940) is available for securing the clamp to shop-made jigs and fixturesHeavy-duty metal construction
Use this lock for right hand applications.Stamped steel lock body--Escutcheon not provided.Key is brass plated.Requires 1-3/8" L x 1-1/8" D x 3/8" mortise.Brass selvedge is 1/2" x 2-3/4" .Keyed alike. Jig It insert available for creating the mortise with our Jig It Mortising System.